Routing II

Description

NSE4 6.0 NSE4 6.0 Quiz on Routing II, created by Marcos Avila on 05/07/2018.
Marcos Avila
Quiz by Marcos Avila, updated more than 1 year ago
Marcos Avila
Created by Marcos Avila over 6 years ago
135
1

Resource summary

Question 1

Question
[blank_start]Source IP (default)[blank_end] Sessions from the same source IP address use the same route. [blank_start]Source—destination IP[blank_end] Sessions with the same source and destination IP use the same route. [blank_start]Weighted[blank_end] Sessions are distributed based on route, or interface weights. [blank_start]Usage (spillover)[blank_end] One route is used until the volume threshold is reached, then the next route is used.
Answer
  • Source IP (default)
  • Source—destination IP
  • Weighted
  • Usage (spillover)

Question 2

Question
Defaul ECMP method on Fortigate
Answer
  • Source IP
  • Weighted

Question 3

Question
How does FortiGate load balance traffic when using the spillover method in ECMP routing? .
Answer
  • a. Sessions are distributed based on interface threshold.
  • b. Sessions are distributed based on route weight.

Question 4

Question
RPF
Answer
  • Reverse Path Forwarding
  • Reverse Port Forwarding

Question 5

Question
RPF Method
Answer
  • Loose Strict
  • Loop Strict

Question 6

Question
[blank_start]strict—src—check disable[blank_end] — Loose RPF (default) Checks only for the existence of at least one active route back to the source using the incoming interface. [blank_start]strict—src—check enable[blank_end] — Strict RPF Checks that the best route back to the source uses the incoming interface.
Answer
  • strict—src—check disable
  • strict—src—check enable

Question 7

Question
Default RPF check method on Fortigate
Answer
  • Loose
  • Strict

Question 8

Question
Which of the following route lookup scenarios Will satisfy the RPF check for a packet?
Answer
  • a. Routing table has an active route for the destination IP of the packet. .
  • b. Routing table has an active route for the source IP of the packet.

Question 9

Question
When using link health monitoring, which route attribute must also be configured to achieve route failover protection?
Answer
  • a. Distance
  • b. Metric
Show full summary Hide full summary

Similar

General ICT Quiz
Jade Fantom
Law of Tort - General Negligence
Sophie.J.E
Key Paintings
Julia Lee
Economic Growth
Kati Christova
Third Space Academia
k.fenbyhulse
GCSE Chemistry C1.1 - Fundamental Ideas in Chemistry
chancice.branscombe
Animal Farm
010534
AS Chemistry - Enthalpy Changes
Sarah H-V
PMP Executing, Monitoring and Controlling Processes
myrdenafrancis
chemsitry as level topic 5 moles and equations
Talya Hambling
The Biological Approach to Psychology
Gabby Wood