6248865
Description
Quiz by Miguel Ángel Martínez Lara, updated more than 1 year ago
|
Created by Miguel Ángel Martínez Lara
about 8 years ago
|
|
Question 1
Question
You can use these to combine two wires, they are often used in electrical work.
Answer
-
Long Nose Pliers
-
Combination Pliers
Question 2
Question
It is the action of join two materials by deforming one of them through the use of a force.
Answer
-
To crimp
-
To cut
-
To screw
Question 3
Answer
- True
- False
Question 4
Question
Long Nose Pliers
Answer
Question 5
Question
I use this tool to cut the end of the wires before crimping them into an RJ-45 connector.
Answer
Question 6
Question
These tools are used to carefully put or extract little electronic components.
Answer
- True
- False
Question 7
Question
This tool is used to tighten or loosen flathead screws.
Answer
-
Slotted screws
-
Flat screwdriver
-
Hex screwdriver
Question 8
Question
Slotted screw
Answer
Question 9
Question
This tool is used to insulate a wire.
Answer
- True
- False
Question 10
Question
This tool is used to crimp a kind of connector with a wire.
Answer
Question 11
Question
These are cutting tools. (Select three)
Answer
Question 12
Question
This is used to avoid an electrical discharge when working on elecronic components.
Answer
- True
- False
Question 13
Question
Tools used to tighten and loosen nuts and bolts. (Select two)
Answer
Question 14
Answer
- True
- False
Question 15
Question
The action of dividing something into smaller pieces.
Answer
-
To crimp
-
To cut
-
To tight
Question 16
Question
What is the first step to solder?
Answer
-
Heat the soldering iron.
-
Make sure the tip is clean.
-
Put the components together.
Question 17
Question
After soldering, the soldering iron should be held for another second to melt the solder before retiring it.
Answer
- True
- False
Question 18
Question
If you have a mistake you can remove it by using a [blank_start]desoldering tool[blank_end].
Answer
-
desoldering tool
-
flux
-
soldering tip
-
component
Question 19
Question
It is important to heat the soldering iron so the solder can be [blank_start]melted[blank_end] on the two components which are going to be bonded.
Answer
-
melted
-
melt
-
melting
-
didn't melt
Want to create your own Quizzes for free with GoConqr? Learn more.