Zusammenfassung der Ressource
River Load
- Dissolved load consists of soluble materials
carried as chemical ions, so there are no
measurable particles
- Large particles only form part of the
load during and immediately after
extreme events that lead to increases in
discharge
- In these
circumstances,
the river increases
it's competence to
allow larger
particles to be
carried
- Large boulders and cobbles often form
the load in the upper course of a river
because it seldom has the energy to be
able to transport it downstream
- In general, the particles decrease in size the
further downstream they are (Bradshaws model),
this is due to increased erosion with processes like
attrition decrease sediment size
- Total sediment yields tend to increase with
distance downstream, mainly due to increases in
average discharge and velocity in the lower
courses. Here, the river posses a greater capacity
and is able to transport more material
- Spatial variations in load can be
seen in rivers across the world due
to the following factors
- Size of drainage basin
- larger basins with many tributaries have a
greater potential for transporting sediment.
- Rock Type
- in areas where the underlying geology
consists of softer rocks like clay and
sandstone, the sediment load consists
mainly of sand or clay particles
- where the rock is limestone, more material will
be transported as dissolved load because
limestone is soluble
- Moving water doesn't easily erode igneous rocks
(like granite and basalt). Therefore, total
sediment yields will be considerably lower
- Relief
- in drainage basins with low relief - a small difference in altitude between the
source and it's base level - the energy available for erosion and transport is
limited
- such rivers have low loads compared with river that
have higher upper reaches in areas of high relief
- Precipitation
- low loads are generally found in areas with low precipitation rates. This is
because less water is available as runoff compared with drainage basins with
high precipitation
- Seasonal differences in sediment yield occur in areas where
the climate has wet and dry seasons - where snow melt in
spring adds to normal run off from precipitation
- Human activity
- in areas where rapid deforestation is taking place, there have been
marked increases in load. mainly caused by increased soil erosion which
occurs because the vegetation that protected the soil from the action of
moviong water have been removed
- there is also reduced uptake of water by trees and other plants
- the result is that soil is washed into the river and adds to the suspended load
- farmers use of nitrates and phosphates as chemical fertilisers means that
these substances enter the river by through flow and overland flow and are
then transported in solution
- the construction of dams will trap sediment,
significantly lowering sediment yields downstream