Brian Gamble
Quiz von , erstellt am more than 1 year ago

CCNA ICND2 (Chapter 10) Quiz am ICND2 Ch 10 quiz, erstellt von Brian Gamble am 03/02/2016.

7
0
0
Brian Gamble
Erstellt von Brian Gamble vor fast 9 Jahre
Schließen

ICND2 Ch 10 quiz

Frage 1 von 8

1

A classful network in which packets sent between at least one pair of subnets must pass through subnets of a different classful network.

Wähle eine der folgenden:

  • Contiguous

  • Discontiguous

Erklärung

Frage 2 von 8

1

A classful network in which packets sent between every pair of subnets can pass only through subnets of that same classful network, without having to pass through subnets of any other classful network.

Wähle eine der folgenden:

  • Contiguous

  • Discontiguous

Erklärung

Frage 3 von 8

1

What is Step 2 for EIGRP configuration?

Wähle eine der folgenden:

  • Impact metric calculations by tuning bandwidth and delay using the bandwidth value and delay value interface subcommand.

  • Set the EIGRP router ID (RID) explicitly with the eigrp router-id value router subcommand

  • Enter configuration mode and define the EIGRP autonomous system number (ASN) by using the router eigrp as-number global command.

  • Configure one or more network ip-address [wildcard-mask] router subcommands. This enables the EIGRP on any matched interface and causes EIGRP to advertise the connected subnet.

Erklärung

Frage 4 von 8

1

Routes that are neither successor nor FS can never be added to the IP routing table regardless of the varianc e setting, because doing so may cause packets to loop.

Wähle eins der folgenden:

  • WAHR
  • FALSCH

Erklärung

Frage 5 von 8

1

R2 has two routes to network 10.0.0.0/8: one pointing left toward R1 and one pointing right toward R3. R2 simply uses its usual load-balancing logic, because as far as R2 can tell the two routes are simply equal-cost routes to the same destination: the entire network 10.0.0.0. Sometimes R2 happens to forward a packet toward the correct destination, and sometimes not. This problem has two solutions; what are they?

Wähle eine oder mehr der folgenden:

  • Create IP addressing plans that do not create discontiguous classful networks

  • Use autosummary by using EIGRP defaults

  • Create IP addressing plans that create discontiguous classful
    networks

  • Do not use autosummary by using EIGRP defaults

Erklärung

Frage 6 von 8

1

The only difference compared to OSPF is that the EIGRP RID is configured with the __________________ router subcommand, whereas OSPF uses the router-id value subcommand.

Wähle eine der folgenden:

  • Router eigrp

  • Eigrp router-id value

  • Show ip route eigrp

  • none of these

Erklärung

Frage 7 von 8

1

What is the report distance (RD)?

Wähle eine der folgenden:

  • What is the report distance (RD)?

  • The metric of the best route to reach a subnet

  • The result of the calculation of the EIGRP metric for a route

  • The metric calculated from the perspective of the next-hop router

Erklärung

Frage 8 von 8

1

In real networks, most people prefer to use autosummary today

Wähle eins der folgenden:

  • WAHR
  • FALSCH

Erklärung

Vorherige
Nächste