PPL 2

1

The process of converting the……............. in fuel into ……………. Takes place in the cylinder of reciprocating engine.

1

An air/fuel ratio of 18:1 would be considered as:

1

For internal cooling, reciprocating engines are especially dependent on:

1

The five events of a four-stroke cycle engine in the order of their occurrence:

1

One of the advantages of VOR against NDB is:

1

Depending on altitude and line of sight, you can use DME facility:

1

The magnetic heading is 350° and the relative bearing to a radio beacon is 240° what would be the magnetic bearing TO that radio beacon?

1

For minimizing the night effect you should:

1

Each dot on the scale of CDI deviation represents:

1

When checking the course sensitivity of a VOR receiver how many degrees should the OBS be rotated to move the CDI from the center to the last dot on either side?

1

Below 18,000 ft AGL, what is the maximum reception distance of HVOR?

1

Dual VORs (units independent of each other except the antenna) are installed in an aircraft. What is the maximum permissible variation between the two bearing indications when one VOR receiver is checked against the other?

1

The primary reason the angle of attack must be increased to maintain a constant altitude during a coordinated turn, is because the:

1

What is a purpose of flight spoilers?

1

An airplane said to be inherently stable will:

1

The capability of an airplane to respond to the pilot's inputs, especially with regard to flight path and attitude, is:

1

All stalls in airplane are caused by:

1

If two aircraft are turning at the same angle of bank the slower aircraft:

1

Which of the following is correct?

1

An accumulation of frost on the airplane wings will result in:

1

Which of the following components is most important in determining longitudinal static stability?

1

When a trailing edge flap is lowered during flight from takeoff position to fully down position, one will experience:

1

In a level banked turn, the stalling speed will:

1

The purpose of streamlining is:

1

Which location on aeroplane has the largest effect on the induced drag?

1

If pressure is kept constant and temperature increases, the density will:

1

A wing has a mean chord of 6 meters and a span of 30 meters. The aspect ratio is: .

1

Every physical process of weather is the result of:

1

Where “St. Elmo’s fire” is usually encountered?

1

Which weather phenomenon is always associated with the passage of a frontal system?

1

In which situation is advection fog most likely to form?

1

The cloud type associated with the most severe turbulence is:

1

A narrow band of non-frontal thunderstorms that often develops ahead of a fast-moving cold front is known as

1

In mountain wave turbulence may be marked by …………… clouds:

1

If the temperature is 55°F and slowly decreasing and the dew point is 51°F what type of weather should you expect?

1

Which of the following clouds produces severe turbulence?

1

Which of the following is true concerning atmospheric pressure?

1

The Payload is defined as:

1

Define the Useful Load:

1

What is the new CG location, if 172 pounds of weight are removed from St. 198"? Airplane gross weight 4200 lbs CG Prior to shift st. 95"

1

What load must be shifted from station 160.0" to station 70.0" to shift CG 0.5 inch forward? Total weight 7400 lbs CG location station 89.0"

1

Takeoff Mass is described as:

1

An aircraft is loaded 110 pounds over maximum certificated gross weight. If fuel is drained to bring the aircraft weight within limits, how much fuel should be drained?

1

The value of variation:

1

An Isogonic is a line:

1

Precession in a gyroscope is:

1

With constant weight and configuration and regardless of an altitude an aircraft always takes off at the same:

1

If the static intakes are completely clogged up by ice during a climb the VSI shows:

1

If both the ram air input and the drain hole of the pitot system becomes blocked, the indicated airspeed will generally:

1

Compass acceleration and deceleration error is maximum at:

1

If a suction gage indicates the pressure to be lower than the minimum limit, which of these air operated instruments would be?

1

Slip is ........

1

The acceptable altimeter error must be within range of ……. To check altimeter before flight:

1

What is the immediate indication of VVI about change in pressure?

1

What would be the TAS when altitude increase or temperature increase?

1

What is the time for heading indicator reset against compass during straight and level unaccelerated flight?

1

Which body system is responsible for distributing oxygen around the body?

1

One of the most common types of spatial disorientation occurs when a rapid correction as made to a bank which may cause to reenter to the original attitude, is:

1

Whenever you are replenishing an aircraft’s oxygen system, always use …………………….. oxygen.

1

When making an approach to a narrower than usual runway, without VASI assistance, the pilot should be aware that the approach:

1

Sudden penetration of fog can create the illusion of:

1

Breathing large amounts of carbon monoxide can result in:

1

When flying at night the first sense to be affected by a slight degree of hypoxia is the:

1

Anxiety and fear can cause:

1

Given: Pressure Altitude: 28,000 ft Outside Air Temperature: -30°C Calibrated Altitude: 27,800 ft Find True Altitude.

1

Given: True Track: 352° Variation: 11° W Deviation: -5° Drift: 10° R What is the compass heading?

1

During a night flight, you see a steady red light and a flashing red light ahead, the other aircraft is:

1

The best method to use when looking for other traffic at night is to:

1

Selection of mode C on the SSR provides ATC with information based on:

1

A mode S transponder will:

1

Which is the correct traffic pattern departure procedure to use at a non-controlled airport?

1

To set the high intensity runway lights on medium intensity (Pilot Controlled Lighting System), the pilot should click the microphone seven times, and then click it:

1

What is the purpose of the runway/runway hold position sign?

1

Taxiway markings and aircraft stand markings are:

1

The “stop way” is a defined rectangular area on the ground at the end of takeoff run available prepared as a suitable area where:

1

What does the word “CANCEL” mean?

1

You obtain a clearance to descend to an altitude of 2500 feet, the clearance should also include the following pressure setting or settings:

1

What does the phrase "BREAKBREAK" mean?

1

A message preceded by the phrase "TRANSMITTING BLIND DUE RECEIVER FAILURE" shall be transmitted:

1

Which of these phrases is used to inform the control tower that a pilot is performing a missed approach?

1

Where the "SELCAL" should be submitted?

1

For which of the following phrases,"ROGER" is used?

1

The standard of noise certification is contained in?

1

All aeroplane on all flights shall carry:

1

The instruments and equipment, including their installation in aeroplanes shall be approved or accepted by:

1

Who is responsible to approve and publish an Instrument approach procedure?

1

If the incident occurs and necessitates to report by Pilot-in-command it shall be made normally within:

1

In a forecast what does the code "GR" stand for?

1

What is the validity of TAF when it issues every 3 hours?

1

What does the code "VV002" in METAR mean?

1

What does the term METAR signify?

1

Anti-collision and navigation light shall be displayed on aircraft during:

1

Which signal may be initiated by, an intercepted aircraft which is in distress?

1

When an aircraft flying on a route with magnetic track of 315 what shall be its assign flight level (non RVSM airspace)?

1

Which one is not correct?

1

Who is the appropriate authority regarding flight over other than the high seas?

1

For which type of operation, the advisory service may be provided?

1

How does a decreased pressure altitude at an airport affect airplane performance?

1

For a piston-engine airplane at a constant altitude, angle of attack and configuration, an increased weight will require:

1

If tailwind is …… takeoff speed the takeoff distance will increase by …… .

Quiz on PPL 2, created by mehdi mohaqeq on 05/05/2017.

PPL 2

The process of converting the……............. in fuel into ……………. Takes place in the cylinder of reciprocating engine.

An air/fuel ratio of 18:1 would be considered as:

For internal cooling, reciprocating engines are especially dependent on:

The five events of a four-stroke cycle engine in the order of their occurrence:

One of the advantages of VOR against NDB is:

Depending on altitude and line of sight, you can use DME facility:

The magnetic heading is 350° and the relative bearing to a radio beacon is 240° what would be the magnetic bearing TO that radio beacon?

For minimizing the night effect you should:

Each dot on the scale of CDI deviation represents:

When checking the course sensitivity of a VOR receiver how many degrees should the OBS be rotated to move the CDI from the center to the last dot on either side?

Below 18,000 ft AGL, what is the maximum reception distance of HVOR?

Dual VORs (units independent of each other except the antenna) are installed in an aircraft. What is the maximum permissible variation between the two bearing indications when one VOR receiver is checked against the other?

The primary reason the angle of attack must be increased to maintain a constant altitude during a coordinated turn, is because the:

What is a purpose of flight spoilers?

An airplane said to be inherently stable will:

The capability of an airplane to respond to the pilot's inputs, especially with regard to flight path and attitude, is:

All stalls in airplane are caused by:

If two aircraft are turning at the same angle of bank the slower aircraft:

Which of the following is correct?