Frage 1
Frage
Which section of the CEC deals with installation of heating units
Antworten
-
Section 12
-
Section 16
-
Section 46
-
Section 62
Frage 2
Antworten
-
Heat energy required to raise the temperature of a litre of water 1F
-
Heat energy required to raise the temperature of a pound of water 1F
-
Heat energy required to raise the temperature of a pound of water 1C
-
Heat energy required to raise the temperature of a litre of water 1C
Frage 3
Frage
Heat transferred by electromagnetic wave motion by which we receive heat from the sun is through?
Antworten
-
Conduction
-
Convection
-
Radiation
-
HVAC units
Frage 4
Frage
What is usually provided on the intake side of the fan in the return air system?
Antworten
-
Supply plenum
-
Power supply filter
-
Filter
-
Flue or stack
Frage 5
Frage
A schematic diagram is used to
Frage 6
Frage
The function of the refrigeration cycle is to
Antworten
-
Removes heat from low temperature body and delivers it to a high temperature body
-
Removes heat from a high temperature body and delivers it to a low temperature body
-
Rejects energy to low temperature body
-
None of the above
Frage 7
Frage
Which section of the CEC covers rules relating to disconnect switches for furnaces?
Antworten
-
Section 12
-
Section 16
-
Section 28
-
Section 62
Frage 8
Frage
Which part of the HVAC system is responsible for compressing the Freon
Antworten
-
Compressor
-
Condenser
-
Evaporator
-
TX valve
Frage 9
Frage
This type of compressor is completely sealed inside a metal housing and is not serviceable
Antworten
-
Hermetic
-
Reciprocating
-
Scroll
-
Semi-hermetic
Frage 10
Frage
What substance is used in a heat cycle to transfer heat from one area, and remove it to another
Antworten
-
Refrigerant
-
Neon
-
Vapor
-
Xenon
Frage 11
Frage
A conventional condenser unit requires a liquid refrigerant which is also called?
Antworten
-
Freon
-
Hydrogen
-
Helium
-
Carbon dioxide
Frage 12
Frage
Which component pushes the hot gas to the finned condenser coil in the outdoor side of the air conditioner
Frage 13
Frage
Two different pressures exist in the refrigeration cycle. Two components that separate the high-pressure side from the low-pressure side are:
Frage 14
Frage
In the cooling mode, what component is located inside the building?
Frage 15
Frage
To go from cooling source in a heat pump, what is required?
Antworten
-
TRX valve
-
4 way reversing valve
-
Double pole thermostat
-
A disconnect switch
Frage 16
Frage
The amount of heat added to the liquid to make it saturated and change states is called
Antworten
-
Super heat
-
Heat energy
-
Latent heat
-
Transferred heat
Frage 17
Frage
Heat, that when added or removed, causes a change in temperature but not in state
Antworten
-
Latent heat
-
Sensible heat
-
Low heat
-
Energy heat
Frage 18
Frage
Refrigerant lines are usually made from
Antworten
-
Aluminum
-
Stainless steel
-
Copper
-
Either a or c
Frage 19
Frage
Which part of a cooling system absorbs heat from the air?
Antworten
-
Condenser
-
Evaporator
-
Compressor
-
Accumulator
Frage 20
Frage
Why is it necessary to have a heating element in a heat pump?
Antworten
-
To eliminate condenser freezing
-
To protect against high outside temperature
-
To protect against low outside temperature
-
To provide heat for the room
Frage 21
Frage
Which statement indicates an acceptable method of supplying power to a 65,000 BTU gas fired hot water furnace?
Antworten
-
Supply furnace from basement lighting
-
Supply furnace from nearest receptacle
-
Supply furnace from smoke detector circuit
-
Supply from dedicated circuit
Frage 22
Frage
What describes heat transfer from one metal to another in a heating system?
Antworten
-
Conduction
-
Radiation
-
Convection
-
Evaporator
Frage 23
Frage
What type of evaporator coil is used in a heat pump?
Antworten
-
Fin tube
-
Helical tube
-
Plate tube
-
Air bay pass tube
Frage 24
Frage
What does a shop drawing show?
Frage 25
Frage
What if the minimum current rating for a disconnect serving a motor compressor?
Frage 26
Frage
A high limit control in a gas furnace control is switched with a fan limit control. What is the result?
Antworten
-
The burner will not ignite
-
The fan will cycle on and off
-
The burner won’t turn off
-
The fan won’t run
Frage 27
Frage
Which calculation determines the size of the overload fuses for motor compressor appliances?