Frage 1
Frage
Which one of the following items will require special attention when using a steam
stripper in a domestic environment?
Antworten
-
a Television.
-
b Desk.
-
c Kettle.
-
d Radiator.
Frage 2
Frage
Plastic sheeting is sometimes placed under cotton dust sheets when protecting furniture.
Why is this?
Antworten
-
a To protect the plastic sheeting.
-
b To prevent dust from transferring through.
-
c To prevent the sheets from slipping off.
-
d To save on the use of cotton sheets.
Frage 3
Frage
Due to its lightness, which one of the following is generally the best sheeting for
covering office equipment?
Antworten
-
a Tarpaulin.
-
b Plastic sheet.
-
c Adhesive plastic.
-
d Cotton twill.
Frage 4
Frage
Which one of the following tapes would be the most suitable for masking a previously
painted surface?
Antworten
-
a Low tack tape.
-
b Duct tape.
-
c Masking tape.
-
d Insulation tape.
Frage 5
Frage
Which one of the following identifies the best reason for carefully removing masking tape
after the painting has been completed?
Antworten
-
a To save time cleaning up.
-
b To allow the paint to flow.
-
c To re-use the masking tape.
-
d To stop paint being lifted off.
Frage 6
Frage
Which one of the following is the most important reason for professionally cleaning dust
sheeting after use?
Frage 7
Frage
Which of the following component parts of a brush is used to bind the setting to the
handle?
Antworten
-
a Ferrule.
-
b Stock.
-
c Frame.
-
d Filling
Frage 8
Frage
A short pile Mohair roller is unsuitable for applying emulsion to an embossed surface
because the
Antworten
-
a roller would over fill the surface
-
b mohair would come away
-
c roller would skim over the surface
-
d rolling would take too long.
Frage 9
Frage
A water-borne gloss is being applied to a window cill. Why might a synthetic filament
brush be used specifically for this task?
Antworten
-
a The filament is easier to clean after use.
-
b The brush marks produce a good texture.
-
c The filament brush is cheaper.
-
d The brush marks are less visible.
Frage 10
Frage
Which one of the following defects may occur if a tin of solvent-borne undercoat paint is
not prepared before use?
Antworten
-
a Delayed drying time.
-
b Increased odour.
-
c Blooming.
-
d Cissing.
Frage 11
Frage
Which one of the following surface coatings allows timber to ‘breathe’?
Antworten
-
a Gloss paint.
-
b Eggshell paint.
-
c Silk-emulsion paint.
-
d Micro-porous paint.
Frage 12
Frage
Which one of the following paint types would not be stirred prior to use?
Antworten
-
a Gloss.
-
b Thixotropic.
-
c Silk-emulsion.
-
d Micro-porous.
Frage 13
Frage
What evaporates when an aluminium primer dries?
Antworten
-
a Cellulose thinner.
-
b Methylated spirit.
-
c Distilled water.
-
d White spirit.
Frage 14
Frage
A common problem associated with gloss paint drying in hot and dry conditions is
Antworten
-
a rapid drying
-
b loss of gloss
-
c cissing
-
d crazing
Frage 15
Frage
The first component of a panelled door to be painted is the
Antworten
-
a stiles
-
b rails
-
c muntins
-
d mouldings.
Frage 16
Frage
If gloss is applied on top of an undercoat of the wrong colour, which defect is likely
to occur?
Antworten
-
a Grinning.
-
b Flashing.
-
c Bleeding.
-
d Bleaching.
Frage 17
Frage
Careless application of solvent-borne gloss by roller can cause which of the following
defects?
Antworten
-
a Blooming.
-
b Cissing.
-
c Crazing.
-
d Skid marks.
Frage 18
Frage
Strongly coloured painted surfaces exposed to direct sunlight over time may experience
Antworten
-
a bleeding
-
b flaking
-
c fading
-
d cissing.
Frage 19
Frage
If a surface is described as ‘friable’, it would appear
Frage 20
Frage
A synthetic filament brush has been used with water-borne gloss paint. Which one of the
following cleaning methods should be used?
Antworten
-
a Remove excess paint, wash in sugar soap.
-
b Remove excess paint, wash in methylated spirit.
-
c Remove excess paint, wash in water.
-
d Remove excess paint, wash in solvent.
Frage 21
Frage
How should roller sleeves be stored after cleaning and drying?
Antworten
-
a Laid flat in a dry place.
-
b Placed upright in a dry place.
-
c Suspended upright in water.
-
d Laid, submerged in water.
Frage 22
Frage
How should materials with low ‘flash points’ be stored?
Frage 23
Frage
An important reason for stock rotation is to
Antworten
-
a prevent stock from degrading
-
b ensure that recent stock is used first
-
c get the best value from bargain prices
-
d minimise the theft of materials.
Frage 24
Frage
Why does paint sometimes ‘skin’ after use?
Antworten
-
a Because the solvent evaporates and the surface drys.
-
b Because the oil has leaked from the bottom of the tin.
-
c Due to inappropriate stirring after use.
-
d Due to an incorrect storage temperature.
Frage 25
Frage
When the components of paint separate in the tin, this is known as
Antworten
-
a crazing
-
b blooming
-
c cissing
-
d settling.