ICND2 Ch 10 quiz

Beschreibung

CCNA ICND2 (Chapter 10) Quiz am ICND2 Ch 10 quiz, erstellt von Brian Gamble am 03/02/2016.
Brian Gamble
Quiz von Brian Gamble, aktualisiert more than 1 year ago
Brian Gamble
Erstellt von Brian Gamble vor fast 9 Jahre
7
0

Zusammenfassung der Ressource

Frage 1

Frage
A classful network in which packets sent between at least one pair of subnets must pass through subnets of a different classful network.
Antworten
  • Contiguous
  • Discontiguous

Frage 2

Frage
A classful network in which packets sent between every pair of subnets can pass only through subnets of that same classful network, without having to pass through subnets of any other classful network.
Antworten
  • Contiguous
  • Discontiguous

Frage 3

Frage
What is Step 2 for EIGRP configuration?
Antworten
  • Impact metric calculations by tuning bandwidth and delay using the bandwidth value and delay value interface subcommand.
  • Set the EIGRP router ID (RID) explicitly with the eigrp router-id value router subcommand
  • Enter configuration mode and define the EIGRP autonomous system number (ASN) by using the router eigrp as-number global command.
  • Configure one or more network ip-address [wildcard-mask] router subcommands. This enables the EIGRP on any matched interface and causes EIGRP to advertise the connected subnet.

Frage 4

Frage
Routes that are neither successor nor FS can never be added to the IP routing table regardless of the varianc e setting, because doing so may cause packets to loop.
Antworten
  • True
  • False

Frage 5

Frage
R2 has two routes to network 10.0.0.0/8: one pointing left toward R1 and one pointing right toward R3. R2 simply uses its usual load-balancing logic, because as far as R2 can tell the two routes are simply equal-cost routes to the same destination: the entire network 10.0.0.0. Sometimes R2 happens to forward a packet toward the correct destination, and sometimes not. This problem has two solutions; what are they?
Antworten
  • Create IP addressing plans that do not create discontiguous classful networks
  • Use autosummary by using EIGRP defaults
  • Create IP addressing plans that create discontiguous classful networks
  • Do not use autosummary by using EIGRP defaults

Frage 6

Frage
The only difference compared to OSPF is that the EIGRP RID is configured with the __________________ router subcommand, whereas OSPF uses the router-id value subcommand.
Antworten
  • Router eigrp
  • Eigrp router-id value
  • Show ip route eigrp
  • none of these

Frage 7

Frage
What is the report distance (RD)?
Antworten
  • What is the report distance (RD)?
  • The metric of the best route to reach a subnet
  • The result of the calculation of the EIGRP metric for a route
  • The metric calculated from the perspective of the next-hop router

Frage 8

Frage
In real networks, most people prefer to use autosummary today
Antworten
  • True
  • False
Zusammenfassung anzeigen Zusammenfassung ausblenden

ähnlicher Inhalt

CCNA Part 1
Axiom42
CCNA Part 2
Axiom42
Chapter 7 quiz
Brian Gamble
DIKTA ICND2 Ch 17
Brian Gamble
CCNA Security 210-260 IINS - Exam 3
Mike M
CCNA Security 210-260 IINS - Exam 1
Mike M
CCNA Security 210-260 IINS - Exam 2
Mike M
DIKTA ICND2 Ch 9
Brian Gamble
DIKTA ICND2 Ch 10
Brian Gamble
Chapter 9 quiz
Brian Gamble
CCNA Answers – CCNA Exam
Abdul Demir