Zusammenfassung der Ressource
Frage 1
Frage
When should the cell unit be installed in the panel?
Antworten
-
After the installer calls in with his Serial Number information
-
Before the panel is powered on.
-
When the power is powered on
-
Both A and C
Frage 2
Frage
Can you use the speaker phone on a GSM account?
Frage 3
Frage
In order to send Signals through Alarm.com what steps need to be taken first?
Antworten
-
Delete phone number in Phone 1.
-
You don’t, the GSM is automatically verified and it turns itself on.
-
Send a Cell test
-
Under System Type, turn off Phone line and turn on GSM.
Frage 4
Frage
Where do you program the Duress code?
Antworten
-
In zone 92
-
There is no Duress on the GC3
-
User programming user codes
-
Fluent does not use a Duress code so it doesn’t matter
Frage 5
Frage
Why would a sensor work only once and then show a fault?
Antworten
-
Low Battery
-
Bad RF range
-
Wrong Loop number
-
Wrong Serial Number
Frage 6
Frage
What is acceptable GSM signal strength?
Antworten
-
2-6
-
6-31
-
0-1
-
None of the above
Frage 7
Frage
What is unacceptable GSM signal strength?
Frage 8
Frage
What is radio modem network failure?
Antworten
-
GSM fault
-
Translator Error
-
Wi-Fi failure
-
Improper Line Seizure
Frage 9
Frage
How many screws are needed to attach the GSM to the back of the panel board?
Antworten
-
2
-
3
-
4
-
No screws are required
Frage 10
Frage
What could happen if the GSM is not installed properly on the back of the panel board?
Frage 11
Frage
At what temp does the Ecolink freeze sensor need to be and how long to send the freeze signal?
Antworten
-
42*F or 6*C for up to 10 minutes
-
Can be customized by customer
-
When it is really cold
-
32*F or 0*C for up to 5 minutes
Frage 12
Frage
2GIG Motion Detectors also have freeze sensors in them?
Frage 13
Frage
2GIG Smoke Detectors also have freeze sensors in them?
Frage 14
Frage
You can have 2 doors with different Delayed Entry times?