power prep quiz 13

Beschreibung

power engineering 3b2 Quiz am power prep quiz 13, erstellt von TRAVIS CANNING am 28/02/2016.
TRAVIS CANNING
Quiz von TRAVIS CANNING, aktualisiert more than 1 year ago
TRAVIS CANNING
Erstellt von TRAVIS CANNING vor mehr als 8 Jahre
2
1

Zusammenfassung der Ressource

Frage 1

Frage
The absolute discharge pressure compared to the absolute intake pressure is referred to as
Antworten
  • guage pressure
  • compression ratio
  • isentropic exponent
  • isothermal compression
  • absolute pressure

Frage 2

Frage
Air at normal atmospheric conditions located at the compressor inlet is termed
Antworten
  • free air
  • interstage air
  • compression air
  • ambient air
  • unloaded air

Frage 3

Frage
The volumetric efficiency of an air compressor is the ratio of
Antworten
  • 1st stage cylinder volume to 2nd stage cylinder volume
  • inlet air temperature compared to discharge air temperature
  • capacity to displaced volume
  • isothermal compression compared to adiabatic compression
  • cylinder volume compared to air receiver volume

Frage 4

Frage
An air compression curve on a pressure-volume diaphragm will be:
Antworten
  • pure polytropic
  • purely isentropic
  • purely isothermal
  • somewhere between constant pressure and constant volume
  • somewhere between adiabatic and isothermal

Frage 5

Frage
The clearance volume on an air compressor
Antworten
  • has no effect on discharge capacity
  • has a direct effect on compressor capacity
  • varies with the speed of the compressor
  • must be large enough to prevent the cylinder overheating
  • is important in the event that there is moisture in the air being compressed

Frage 6

Frage
An air compressor at a significantly higher altitude compared to an air compressor at a lower altitude will deliver:
Antworten
  • less volume of air
  • higher volume of air
  • less mass of air
  • more mass of air
  • an equal mass of air

Frage 7

Frage
The effect of moisture in a compressed air system is detrimental because:
Antworten
  • it will lower the discharge air temperature
  • it will cause corrosion in the air piping
  • it will freeze in the winter
  • it will plug the actuators
  • it requires more power to compress the air

Frage 8

Frage
The term dewpoint is defined as
Antworten
  • saturation pressure of the air
  • the temperature of the air when it begins to absorb moisture
  • relative humidity
  • the temperature of the air when water vapour begins to condense
  • none of the above

Frage 9

Frage
Air compressors may be classified as either:
Antworten
  • positive displacement and dynamic
  • single acting and double acting
  • single stage and multi stage
  • positive displacement and negative displacement
  • centrifugal and reciprocating

Frage 10

Frage
which type of air compressor is best suited for high pressure, moderate volume applications
Antworten
  • reciprocating
  • centrifugal
  • rotary
  • dynamic
  • axial

Frage 11

Frage
A reciprocating air compressor compared to a rotary air compressor is:
Antworten
  • more efficient
  • less efficient
  • equally efficient
  • easier to operate
  • requires less lubrication

Frage 12

Frage
which of the following is a positive displacement compressor:
Antworten
  • axial
  • centrifugal
  • turbine
  • reciprocating
  • none of the above

Frage 13

Frage
A reciprocating compressor has the ability to deliver oil-free air if:
Antworten
  • no oil is used to lubricate the cylinder
  • the piston uses Teflon rings
  • if the exhaust air is filtered prior to entering the air reciever
  • not possible to deliver oil free air
  • synthetic oil is used instead of conventional oil

Frage 14

Frage
A reciprocating air compressor is suitable for:
Antworten
  • pulsation free air
  • low pressure applications
  • all pressure ranges
  • delivering moisture free air
  • all of the above

Frage 15

Frage
The piston on an air compressor may be made of
Antworten
  • alloy steel
  • cast iron
  • steel
  • aluminum
  • all of the above

Frage 16

Frage
A double-acting reciprocating compressor:
Antworten
  • has more than one stage
  • may compress more than one fluid at a time
  • must utilize an intercooler
  • receives and discharges air at both ends of the cylinder
  • is of a dynamic axial design
Zusammenfassung anzeigen Zusammenfassung ausblenden

ähnlicher Inhalt

Thromboseprophylaxe
tia.weber
B, Kapitel 2, Arbeits- und Sozialordnung
Stefan Kurtenbach
KPOL PuKW
Mona Les
A2 Wechselpräpositionen
Anna Kania
Enzyme
Cornelius Ges
BAS1 Funktion von Kreislauf und Atmung
dennis.konscholke
Pädagogik Abitur 2016: Jean Piaget
Lena S.
FOST 2 Deskriptive und explorative Datenanalyse
Kathy H
GPSY ALPS
Malte Ni
Vetie Histopatho 2014
Ann-Kathrin Riedel
Vetie - AVO 2018
Schmolli Schmoll