Test 2 Tools

You can use these to combine two wires, they are often used in electrical work.

It is the action of join two materials by deforming one of them through the use of a force.

This is a Phillips Screwdriver

Long Nose Pliers

I use this tool to cut the end of the wires before crimping them into an RJ-45 connector.

These tools are used to carefully put or extract little electronic components.

This tool is used to tighten or loosen flathead screws.

Slotted screw

This tool is used to insulate a wire.

This tool is used to crimp a kind of connector with a wire.

These are cutting tools. (Select three)

This is used to avoid an electrical discharge when working on elecronic components.

Tools used to tighten and loosen nuts and bolts. (Select two)

Torque wrench

The action of dividing something into smaller pieces.

What is the first step to solder?

After soldering, the soldering iron should be held for another second to melt the solder before retiring it.

If you have a mistake you can remove it by using a [blank_start]desoldering tool[blank_end].

It is important to heat the soldering iron so the solder can be [blank_start]melted[blank_end] on the two components which are going to be bonded.