33263450
Beschreibung
Karteikarten von Joey Higgins, aktualisiert more than 1 year ago
|
Erstellt von Joey Higgins
vor etwa 3 Jahre
|
|
| Frage | Antworten |
| Cutter Comp Cancel | G40 |
| Rapid Traverse Motion | G00 |
| Spindle Stop | M05 |
| Linear Interpolation Motion | G01 |
| Circular Interpolation Motion, Clockwise | G02 |
| Tool Change | M06 |
| Absolute Programming Positioning | G90 |
| Circular Interpolation Motion, Counter-Clockwise | G03 |
| Cutter Comp RIGHT of programmed path | G42 |
| Subprogram Call | M98 |
| Tool Length Compensation + | G43 |
| Work Coordinate #1 (Part Zero Offset) | G54 |
| Canned Cycle Cancel | G80 |
| Coolant ON Command | M08 |
| Drill Canned Cycle | G81 |
| Tapping Canned Cycle | G84 |
| Incremental Programming Positioning | G91 |
| Canned Cycle Rapid Plane Return | G99 |
| The _____ code is used for a Program Stop command on the machine. It stops the spindle, turns off coolant and stops look-ahead processing. Pressing CYCLE START again will continue the program on the next block of the program. | M00 |
| Spindle Start Clockwise | M03 |
| Spindle Start Counter-Clockwise | M04 |
| Coolant OFF Command | M09 |
| Program End and Reset to beginning of program | M30 |
| Local Subroutine Call | M97 |
| Subprogram Return (M98) or Subroutine Return (M97), or a Program loop | M99 |
| Cutter Compensation LEFT of the programmed path | G41 |
| Machine Home (Rapid Traverse) | G28 |
| Spot Drill Canned Cycle | G82 |
| The ____ code is used for an Optional Program Stop command. Pressing the OPT STOP key on the control panel signals the machine to perform a stop command when the control reads an ____ command. It will then perform like an M00. | M01 |
| Peck Drill Canned Cycle | G83 |
| Machine Coordinate Positioning, Non-Modal | G53 |
| Canned Cycle Initial Point Return | G98 |
Möchten Sie mit GoConqr kostenlos Ihre eigenen Karteikarten erstellen? Mehr erfahren.