Created by cassie mccombie
over 6 years ago
|
||
Question | Answer |
bunsen burner | A Bunsen burner, named after Robert Bunsen, produces a single open gas flame, which is used for heating, sterilization, and combustion |
ring stand | A ring stand is a piece of scientific equipment, clamps can be attached to hold other pieces of equipment such as burettes, test tubes and flasks. |
pipestem triangle | A piece of laboratory equipment that is used to support a crucible being heated by a Bunsen burner or other heat source. |
utility clamp | A piece of laboratory equipment that is used to hold rounded laboratory glassware, for example, a beaker, flask, etc. |
iron ring | Iron rings are commonly used in chemistry laboratories for supporting apparatus above the work surface |
evaporating dish | Used to evaporate excess solvents - most commonly water - to produce a concentrated solution or a solid precipitate of the dissolved substance. |
mortar and pestle | Used to prepare ingredients or substances by crushing and grinding them into a fine paste or powder |
test tubes | A test tube is a clear glass or plastic container that is used to hold, mix, and heat chemical experiments. |
crucible and cover | Crucible are used in the laboratory to contain chemical compounds when heated to extremely high temperatures |
beaker | A beaker is a simple "container" which is used for heating and stirring liquids in laborartories |
safety goggles | duh |
corks | duh |
watch glass | used in chemistry as a surface to evaporate a liquid, to hold solids while being weighed, for heating a small amount of substance and as a cover for a beaker. |
Erlenmeyer flask | A flask that has a flat bottom with a tapered neck. The mouth, or opening, is used for pouring solutions and may be closed with a stopper in order to store samples. |
wire gauze | Wire gauze is used in combination with a Bunsen burner. It is a heat-resistant wire mesh on which beakers or other glassware are supported during heating |
rubber stoppers | same as corks |
buret | Used in quantitative chemical analysis to measure the volume of a liquid or a gas. It consists of a graduated glass tube with a stopcock (turning plug, or spigot) at one end. |
pipet | Used in chemistry, biology and medicine to transport a measured volume of liquid |
thermometer | Determines temperature |
graduated cylinder | A common piece of laboratory equipment used to measure volume |
wash bottle | A squeeze bottle with a nozzle, used to rinse various pieces of laboratory glassware, such as test tubes and round bottom flasks |
micropipets | Same as pipet, but smaller |
dropper | Used to transfer small quantities of liquids |
test tube holder | Used for holding a test tube in place when the tube is hot or should not be touched |
lab burner | same as Bunsen burner |
forceps | Used when fingers are too large to grasp small objects or when many objects need to be held at one time while the hands are used to perform a task |
file | Used to remove fine amounts of material from a workpiece. |
wire brush | Used for cleaning test tubes and narrow mouth laboratory glassware, such as beakers and flasks |
24-well plate | A flat plate with multiple "wells" used as small test tubes |
scoopula | Used primarily in chemistry lab settings to transfer solids: to a weigh paper for weighing, to a cover slip to measure melting point, or a graduated cylinder, or to a watch glass from a flask or beaker through scraping. |
spatula | Used for scraping, transferring, or applying powders and paste like chemicals or treatments |
funnel | Used to channel liquid or fine-grained substances into containers with a small opening. |
test-tube rack | Used to hold upright multiple test tubes at the same time. |
(crucible) tongs | Large pincers for grasping and lifting vessels of heat-resistant material used in high temperature chemical reactions |
Want to create your own Flashcards for free with GoConqr? Learn more.