CNNA 1 V4.0 - Chapter 10 & 11

Question 1 of 17

1

2. Which three statements are true about the role of routers in the network? (Choose three.)

Select one or more of the following:

They propagate broadcasts.
They enlarge collision domains.
They segment broadcast domains.
They interconnect different network technologies.
Each router interface requires a separate network or subnet.
They maintain a common frame format between LAN and WAN interfaces.

Explanation

Question 2 of 17

1

Refer to the exhibit. Which three statements are true about the exhibited topology? (Choose three.)

Select one or more of the following:

Hosts B and C are in the same subnet.
Five broadcast domains are present.
Host B is using a crossover cable to connect to the router.
Four broadcast domains are present.
Five networks are shown.
Host B is using a rollover cable to connect to the router.

Explanation

Question 3 of 17

1

6. Which three types of connectors are commonly associated with Cisco’s V.35 serial cables? (Choose three.)

Select one or more of the following:

RJ 11
DB 60
Winchester 15 pin
DB 9
smart serial
RJ 45

Explanation

Question 4 of 17

1

7. How many host addresses may be assigned on each subnetwork when using the 130.68.0.0 network address with a subnet mask of 255.255.248.0?

Select one of the following:

30
256
2046
2048
4094
4096

Explanation

Question 5 of 17

1

Refer to the exhibit. Which three statements identify the type of cabling that would be used in the segments that are shown? (Choose three.)

Select one or more of the following:

Segment 1 uses backbone cabling.
Segment 1 uses a patch cable.
Segment 3 uses patch cabling.
Segment 3 uses vertical cabling.
Segment 3 uses horizontal cabling.
Segment 4 uses vertical cabling.

Explanation

Question 6 of 17

1

Refer to the exhibit. How many subnets are required to support the network that is shown?

Select one of the following:

2
3
4
5

Explanation

Question 7 of 17

1

14. What does the term “attenuation” mean in data communication?

Select one of the following:

loss of signal strength as distance increases
time for a signal to reach its destination
leakage of signals from one cable pair to another
strengthening of a signal by a networking device

Explanation

Question 8 of 17

1

Refer to the exhibit. A network technician has been allocated the 192.168.1.0/24 private IP address range for use in the network that shown in the exhibit. Which subnet mask would be used to meet the host requirements for segment A of this internetwork?

Select one of the following:

255.255.255.128
255.255.255.192
255.255.255.224
255.255.255.240
255.255.255.248

Explanation

Question 9 of 17

1

21. What are two common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose two.)

Select one or more of the following:

cable color code association
cable selection and configuration
use of cable testers to determine pinouts
the automatic detection and negotiating of MDI/MDIX operation of the port
the enabling of the mechanism to electrically swap the transmit and receive pairs

Explanation

Question 10 of 17

1

24. What are three common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose three.)

Select one or more of the following:

direct configuration of the device
cable color code association
cable selection and configuration
use of cable testers to determine pinouts
the enabling of the mechanism to electrically swap the transmit and receive pairs
the automatic detection and negotiating of MDI/MDIX operation of the port

Explanation

Question 11 of 17

1

Refer to the exhibit. A technician applies the configuration in the exhibit to a clean router. To verify the configuration, the technician issues the show running-config command in the CLI session with the router. What lines should the technician expect to see in the router output from the show running-config command?

Select one of the following:

enable password class
line console 0
password ccna
enable secret cisco
enable password class
line console 0
password ccna
enable secret 5 $1$v0/3$QyQWmJyT7zCa/yaBRasJm0
enable password class
line console 0
password ccna
enable secret cisco
enable password 7 14141E0A1F17
line console 0
password 7 020507550A
enable secret 5 $1$v0/3$QyQWmJyT7zCa/yaBRasJm0
enable password 7 14141E0A1F17
line console 0
password 7 020507550A

Explanation

Question 12 of 17

1

Refer to the exhibit. A network administrator on HostA has problems accessing the FTP server. Layer three connectivity testing was successful from HostA to the S1 interface of RouterB. Which set of commands will allow the network administrator to telnet to RouterB and run debug commands?

Select one of the following:

RouterB(config)# enable secret class
RouterB(config)# line vty 0 4
RouterB(config-if)# login
RouterB(config)# enable secret class
RouterB(config)# line vty 0 2
RouterB(config-vty)# password cisco
RouterB(config-vty)# login
RouterB(config)# enable secret class
RouterB(config)# line vty 0
RouterB(config-line)# password cisco
RouterB(config-line)# login
RouterB(config)# enable secret class
RouterB(config)# line aux 0
RouterB(config-line)# password cisco
RouterB(config-line)# login
RouterB(config)# enable secret class
RouterB(config)# line aux 0
RouterB(config-vty)# password cisco
RouterB(config-vty)# login

Explanation

Question 13 of 17

1

Refer to the exhibit. Which names correctly identify the CLI mode represented by the prompt for Switch-East4#? (Choose two.)

Select one or more of the following:

line configuration mode
user executive mode
global configuration mode
privileged executive mode
interface configuration mode
enable mode

Explanation

Question 14 of 17

1

Refer to the exhibit. The output is shown for the show ip route command executed on Router A. What does the IP address 192.168.2.2 represent?

Select one of the following:

Gateway for the 192.168.1.0 network
Gateway for the 192.168.3.0 network
IP assigned to the serial port on Router A
IP assigned to the serial port on Router B

Explanation

Question 15 of 17

1

13. Which three terms correctly define the forms of help available within the Cisco IOS? (Choose three.)

Select one or more of the following:

hot keys
context-check
context-sensitive
structured check
command override
command syntax check

Explanation

Question 16 of 17

1

Refer to the exhibit. A student is responsible for the IP addressing, configuration and connectivity testing of the network shown in the graphic. A ping from host B to host C results in a destination unreachable but a ping from host B to host A was successful. What two reasons could account for this failure based on the graphic and partial router output for the Dallas router? (Choose two.)

Select one or more of the following:

The host A is turned off.
The Fa0/0 interface on Dallas is shutdown.
The LAN cable is disconnected from host B.
The S0/0/1 IP address of Dallas is improperly configured.
The Fa0/0 interface on Dallas is in a different subnet than host B.
The clock rate is missing on the serial link between Dallas and NYC.

Explanation

Question 17 of 17

1

The connection between routers B and C has been successfully tested. However, after rebooting router C, the administrator noticed the response time between networks 10.10.3.0 and 10.10.4.0 is slower. Ping between the two routers is successful. A trace route indicates three hops from router B to router C. What else can be done to troubleshoot the problem?

Select one of the following:

Ping router B S0/1 connection from router C.
Trace the connection between router B to router C S0/1.
Issue a show ip route command in router B to verify routing is enabled.
Issue a show interfaces command on router C.

	Created by JJ CD almost 10 years ago

Preguntas mas importantes de los dos ultimos capitulos del curso

CNNA 1 V4.0 - Chapter 10 & 11

Question 1 of 17

2. Which three statements are true about the role of routers in the network? (Choose three.)

Select one or more of the following:

Explanation

Question 2 of 17

Refer to the exhibit. Which three statements are true about the exhibited topology? (Choose three.)

Select one or more of the following:

Explanation

Question 3 of 17

6. Which three types of connectors are commonly associated with Cisco’s V.35 serial cables? (Choose three.)

Select one or more of the following:

Explanation

Question 4 of 17

7. How many host addresses may be assigned on each subnetwork when using the 130.68.0.0 network address with a subnet mask of 255.255.248.0?

Select one of the following:

Explanation

Question 5 of 17

Refer to the exhibit. Which three statements identify the type of cabling that would be used in the segments that are shown? (Choose three.)

Select one or more of the following:

Explanation

Question 6 of 17

Refer to the exhibit. How many subnets are required to support the network that is shown?

Select one of the following:

Explanation

Question 7 of 17

14. What does the term “attenuation” mean in data communication?

Select one of the following:

Explanation

Question 8 of 17

Refer to the exhibit. A network technician has been allocated the 192.168.1.0/24 private IP address range for use in the network that shown in the exhibit. Which subnet mask would be used to meet the host requirements for segment A of this internetwork?

Select one of the following:

Explanation

Question 9 of 17

21. What are two common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose two.)

Select one or more of the following:

Explanation

Question 10 of 17

24. What are three common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose three.)

Select one or more of the following:

Explanation

Question 11 of 17

Select one of the following:

Explanation

Question 12 of 17

Refer to the exhibit. A network administrator on HostA has problems accessing the FTP server. Layer three connectivity testing was successful from HostA to the S1 interface of RouterB. Which set of commands will allow the network administrator to telnet to RouterB and run debug commands?

Select one of the following:

Explanation

Question 13 of 17

Refer to the exhibit. Which names correctly identify the CLI mode represented by the prompt for Switch-East4#? (Choose two.)

Select one or more of the following:

Explanation

Question 14 of 17

Refer to the exhibit. The output is shown for the show ip route command executed on Router A. What does the IP address 192.168.2.2 represent?

Select one of the following:

Explanation

Question 15 of 17

13. Which three terms correctly define the forms of help available within the Cisco IOS? (Choose three.)

Select one or more of the following:

Explanation

Question 16 of 17

Select one or more of the following:

Explanation

Question 17 of 17

Select one of the following:

Explanation