Brian Gamble
Quiz by , created more than 1 year ago

Final / Review ICND 1 Quiz on DIKTA ICND 1 Ch 15, created by Brian Gamble on 03/03/2016.

42
0
0
Brian Gamble
Created by Brian Gamble over 8 years ago
Close

DIKTA ICND 1 Ch 15

Question 1 of 6

1

Which of the following installation steps are typically required on a Cisco router, but not typically required on a Cisco switch? (Choose two answers.)

Select one or more of the following:

  • Connect Ethernet cables

  • Connect serial cables

  • Connect to the console port

  • Connect the power cable

  • Turn the on/off switch to “on”

Explanation

Question 2 of 6

1

Which of the following commands might you see associated with the router CLI, but not with the switch CLI?

Select one of the following:

  • The clock rate command

  • The ip address address mask command

  • The ip address dhcp command

  • The interface vlan 1command

Explanation

Question 3 of 6

1

You just bought two Cisco routers for use in a lab, connecting each router to a different LAN switch with their Fa0/0 interfaces. You also connected the two routers’ serial interfaces using a back-to-back cable. Which of the following steps are not required to be able to forward IPv4 packets on both routers’ interfaces? (Choose two answers.)

Select one or more of the following:

  • Configuring an IP address on each router’s Fast Ethernet and serial interfaces

  • Configuring the bandwidth command on one router’s serial interface

  • Configuring the clock rate command on one router’s serial interface

  • Setting the interface description on both the Fast Ethernet and serial interface of each router

Explanation

Question 4 of 6

1

The output of the show ip interface brief command on R1 lists interface status codes of “down” and “down” for interface Serial 0/0. Which of the following could be true?

Select one of the following:

  • The shutdown command is currently configured for that interface

  • R1’s serial interface has been configured to use Frame Relay, but the router on the other end of the serial link has been configured to use PPP.

  • R1’s serial interface does not have a serial cable installed.

  • Both routers have been cabled to a working serial link (CSU/DSUs included), but only one router has been configured with an IP address.

Explanation

Question 5 of 6

1

Which of the following commands do not list the IP address and mask of at least one interface? (Choose two answers.)

Select one or more of the following:

  • show running-config

  • show protocols type number

  • show ip interface brief

  • show interfaces

  • show version

Explanation

Question 6 of 6

1

Which of the following is different on the Cisco switch CLI as compared with the Cisco router CLI?

Select one of the following:

  • The commands used to configure simple password checking for the console

  • The number of IP addresses configured

  • The configuration of the device’s host name

  • The configuration of an interface description

Explanation

Previous
Next