[blank_start]Source IP (default)[blank_end] Sessions from the same source IP address use the same route.
[blank_start]Source—destination IP[blank_end] Sessions with the same source and destination IP use the same route.
[blank_start]Weighted[blank_end] Sessions are distributed based on route, or interface weights.
[blank_start]Usage (spillover)[blank_end] One route is used until the volume threshold is reached, then the next route is used.
Answer
Source IP (default)
Source—destination IP
Weighted
Usage (spillover)
Question 2
Question
Defaul ECMP method on Fortigate
Answer
Source IP
Weighted
Question 3
Question
How does FortiGate load balance traffic when using the spillover method in ECMP routing? .
Answer
a. Sessions are distributed based on interface threshold.
b. Sessions are distributed based on route weight.
Question 4
Question
RPF
Answer
Reverse Path Forwarding
Reverse Port Forwarding
Question 5
Question
RPF Method
Answer
Loose
Strict
Loop
Strict
Question 6
Question
[blank_start]strict—src—check disable[blank_end] — Loose RPF (default)
Checks only for the existence of at least one active route back to the source using the incoming interface.
[blank_start]strict—src—check enable[blank_end] — Strict RPF
Checks that the best route back to the source uses the incoming interface.
Answer
strict—src—check disable
strict—src—check enable
Question 7
Question
Default RPF check method on Fortigate
Answer
Loose
Strict
Question 8
Question
Which of the following route lookup scenarios Will satisfy the RPF check for a packet?
Answer
a. Routing table has an active route for the destination IP of the packet. .
b. Routing table has an active route for the source IP of the packet.
Question 9
Question
When using link health monitoring, which route attribute must also be configured to achieve route failover protection?