Question 1
Question
A network technician notices the site to site VPN and Internet connection have not come back up at a branch office after a recent power outage. Which of the following is an out of band method the technician would MOST likely utilize to check the branch office's router status?
Answer
-
Use a modem to console in to the router
-
Walk a user through troubleshooting the connection
-
Travel to the branch office
-
Hire a contractor to go on site
Question 2
Question
A network technician has salvaged several Ethernet cable from a data center. The technician attempts to use the cables to connect desktops to the network without success. Which of the following is MOST likely the issue?
Answer
-
The cables have an incorrect pinout
-
The cables are UTP instead of STP
-
The cables are CAT 6 instead of CAT5
-
The cables are not plenum rated
Question 3
Question
Which of the following devices sits on the outermost reach of your network?
Answer
-
Firewall
-
Modem
-
Switch
-
Hub
Question 4
Question
What are some of the environmental requirements of infrastructure devices? (e.g. routers, switches, appliances)
Answer
-
Cool Temperature
-
Proper humidity
-
Proper ventilation
-
Proper lighting
Question 5
Question
What are the hexadecimal equivalent of these decimal values?
2 = [blank_start]2[blank_end]
7 = [blank_start]7[blank_end]
11 = [blank_start]B[blank_end]
14 = [blank_start]E[blank_end]
15 = [blank_start]F[blank_end]
Answer
-
1
-
2
-
A
-
4
-
5
-
7
-
11
-
C
-
B
-
D
-
E
-
10
-
8
-
G
-
F
Question 6
Question
Which dedicated application device is ver processor intensive and can interfere with router and switch functions?
Answer
-
Hub
-
Encryption device
-
Packet shaper
-
Analog modem
Question 7
Question
What happens if a server room is too damp?
Question 8
Question
Of the following options, which protocols work at the process/application layer?
Question 9
Question
What protocol is used to find a MAC address to IP address?
Question 10
Question
Which protocols are TCP?
Question 11
Question
A network administrator is assigned to run and connect a Cat 6e Ethernet cable between two nodes in a datacenter. Which of the following connector types should the network administrator use to terminate this cable?