1782988
Descripción
Test por yousweetdreams, actualizado hace más de 1 año
|
Creado por yousweetdreams
hace casi 10 años
|
|
Pregunta 1
Pregunta
A colour laser printer must mix the different colours of toner to produce images and pictures. Where in the printer are the different colours of toner mixed together?
Respuesta
-
The toner drum cavity
-
The sublimation receptacle
-
The primary corona
-
The additive colour palette
-
The transfer belt
Pregunta 2
Pregunta
If the data transfers on your parallel SCSI bus has become corrupt, the problem is probably:
Respuesta
-
SCSI ID is set too low
-
SCSI CMOS battery is low or dead
-
Host adapter isn't gounded in PCI-X slot
-
Termination isn't set
-
SCSI cable is backwards
Pregunta 3
Pregunta
If your system memory count at boot seems to be a little lower than expected, it could be because:
Respuesta
-
There is a memory leak
-
The boot.ini file is configured to limit the amount of memory
-
A continuity module is missing
-
The integrated video adapter is using some of it
-
The memory controller has been disabled
Pregunta 4
Pregunta
DVD drives employ region protection codes that you may need to change in order to read a disc from a different region. Which of the following stores the remaining number of region code changes in the firmware of the optical drive?
Respuesta
-
RPC 0
-
RPC 1
-
RPC 3
-
RPC 2
-
RPC 5
Pregunta 5
Pregunta
Under tight tolerance, +11.4 volts would be acceptable on:
Respuesta
-
A white wire
-
A yellow wire
-
A red wire
-
A blue wire
-
None of the above
Pregunta 6
Pregunta
Bond weight of paper is measured by the weight of:
Respuesta
-
256 sheets of 16" x 9"
-
500 sheets of 17" x 22"
-
500 sheets of 8 1/2" x 14"
-
1000 sheets of 8 1/2" x 11"
-
1000 sheets of 10" by 20"
Pregunta 7
Pregunta
If you're troubleshooting a laser printer problem, and successfully print off a printer self-test page, which of the following has not been ruled out as the problem?
Respuesta
-
Fuser assembly failure
-
Incorrect driver
-
Primary corona failure
-
Low toner
-
Laser failure
Pregunta 8
Pregunta
How would you configure termination on a SAS (Serial Attached SCSI) hard drive?
Respuesta
-
Using the host adapter BIOS
-
Using a DIP switch on the drive
-
Using a SAS setup program
-
Using a resistor pack
-
You don't configure termination on a SAS hard drive
Pregunta 9
Pregunta
You arrive at work and find that a system that you had shut down at the end of the previous day was now powered up and running. Which of the following could you use to quickly determine exactly when that system was powered on?
Respuesta
-
Boot Configuration Data Editor
-
Device Manager
-
Event Viewer
-
Task Manager
-
Windows Memory Diagnostic Tool
Pregunta 10
Pregunta
When an inkjet printer cleans dried ink from its nozzles, a lot of ink is wasted. Where is this ink collected?
Respuesta
-
In the piezo canister
-
In the waste ink recycle reservoir
-
In the ozone filter
-
In the spittoon
-
In the transfer syphon assembly
Pregunta 11
Pregunta
Which of the following is a health and safety concern for a technician working on a laser printer?
Respuesta
-
Shock hazard
-
Ozone inhalation
-
Burn hazard
-
Toner inhalation
-
All of these answers
Pregunta 12
Pregunta
You're going to be upgrading the memory in a client's system and have found some RAM that appears to suit your needs. It's advertised as: 2x4GB PC3-10666 1.5v CL9 Dual Channel Kit. What does the CL9 indicate?
Respuesta
-
Cache level
-
CLV limitation
-
Cooling logic
-
Continuity level
-
CAS latency
Pregunta 13
Pregunta
If a piece of paper jams in a laser printer, you should try to pull it backward through the printer in the opposite direction it normally travels.
Respuesta
- True
- False
Pregunta 14
Pregunta
The lifetime of a sample pool of devices has three phases. The third phase is called:
Respuesta
-
Constant failure phase
-
Expiration phase
-
Wear-out phase
-
Random death phase
-
Infant mortality phase
Pregunta 15
Pregunta
How should you clean up spilled toner?
Respuesta
-
With hot water
-
With a household vacuum
-
With compressed air
-
With a toner vacuum
-
With an MOV
Pregunta 16
Pregunta
When connecting a SATA optical drive, the data cable maximum length is 18 inches.
Respuesta
- True
- False
Pregunta 17
Pregunta
Colour laser printers usually have four different toner cartridges. Which of the following is not one of them?
Respuesta
-
Magenta toner cartridge
-
Blue toner cartridge
-
Cyan toner cartridge
-
Yellow toner cartridge
-
Black toner cartridge
Pregunta 18
Pregunta
Which of the following statements is true?
Respuesta
-
DDR3 memory modules always have tin contacts
-
When mixing speeds of RAM, all of the memory will work at the speed of the slowest module.
-
If a motherboard supports two different types of memory, you can use both at the same time
-
Continuity modules are used with DDR3 memory
-
None of these answers
Pregunta 19
Pregunta
During with step in the laser printing process is the paper given a small charge?
Respuesta
-
Transferring
-
Writing/exposing
-
Charging/conditioning
-
Fusing
-
Cleaning
Pregunta 20
Pregunta
If a windows system has the wrong sound card driver installed, it will always have a yellow exclamation mark on it in the device manager.
Respuesta
- True
- False
Pregunta 21
Pregunta
Which of the following statements about optical discs is true?
Respuesta
-
Blu-ray discs can have region codes
-
Optical discs should be cleaned by wiping in a circular pattern
-
Optical drives require an optical cable
-
Optical discs are prone to failure because of ESD damage
-
Burned DVDs have a much longer expected shelf life than stamped DVDs
Pregunta 22
Pregunta
Which Windows 7 recovery option would automatically take a number of steps including running a memory test and rolling back unresponsive drivers?
Respuesta
-
System image recovery
-
System restore
-
System repair
-
System manager
-
None of these answers
Pregunta 23
Pregunta
Repeated paper jams in the same part of the printer is a sign of:
Respuesta
-
Incorrect paper type
-
Failure of the primary grid
-
Failure of the laser
-
Incorrect drivers
-
USB header cable failure
Pregunta 24
Pregunta
A double-sided, double-layer DVD disc is known as a:
Respuesta
-
DVD-5 disc
-
DVD-9 disc
-
DVD-15 disc
-
DVD-18 disc
-
DVD-24 disc
Pregunta 25
Pregunta
What part of a printer allows it to print on both sides of a page automatically?
Respuesta
-
Inverter
-
Imager
-
Infuser
-
Duplexer
-
Degausser
Pregunta 26
Pregunta
Performing routine maintenance on systems that you're supporting is important to their reliability and stability. Which of the following maintenance items is generally performed the least frequently?
Respuesta
-
Running a virus scan on the system
-
Physical cleaning of the inside of the computer
-
Installing Windows updates
-
Running a defragmenting program on a mechanical hard drive
-
Updating the anti-virus program
Pregunta 27
Pregunta
Which of the following is currently used in optical drives?
Respuesta
-
ZCSV
-
ZCRV
-
ZVLC
-
ZCLV
-
ZCRC
Pregunta 28
Pregunta
You can usually print a Windows test page without sending data from the computer to the printer.
Respuesta
- True
- False
Pregunta 29
Pregunta
Which of the following is a statistic to help determine how many spare devices you should have on hand, but does not accurately specify when one specific device will fail?
Respuesta
-
UEFI
-
FMBR
-
ASPI
-
MTBF
-
SPTI
Pregunta 30
Pregunta
PC3-12800 memory is also known as DDR2-1600
Respuesta
- True
- False
Pregunta 31
Pregunta
Which of the following is not a reason why multiple sheets may be pulled into a printer at once causing a paper jam?
Respuesta
-
The paper is stored in an area that's too humid
-
Using low quality paper
-
Paper is stored in an area that's too dry
-
Worn primary corona
Pregunta 32
Pregunta
Which of the following parallel SCSI connectors is a male connector?
Respuesta
-
Wide SCSI connector on a ribbon cable
-
Wide SCSI connector on a SCSI card
-
Narrow SCSI connector on a ribbon cable
-
Wide SCSI connector on a hard drive
-
None of these answers
Pregunta 33
Pregunta
If you're working on a desktop system that isn't booting to the operating system, doesn't show anything on the monitor, and has a beep code of a repeating single long beep, which one of the following is most likely to be the problem?
Respuesta
-
Incorrect BIOS
-
Missing CPU
-
Dislodged RAM
-
SATA cable backwards
-
Failed SCSI card
Pregunta 34
Pregunta
Which voltage was frequently supplied by older ATX power supplies but is not longer found on newer versions?
Respuesta
-
+3.3 volts
-
-5 volts
-
+12 volts
-
+5 volts
-
-12 volts
Pregunta 35
Pregunta
In some PCs you can mix DDR2 and DDR3 modules within a memory channel, but it will default to the speed of the slowest module.
Respuesta
- True
- False
Pregunta 36
Pregunta
Many sound cards have colour-coded connectors. What is the green 3.5mm connector for?
Respuesta
-
Front speakers
-
Rear speakers
-
Microphone
-
Line in
-
Subwoofer
Pregunta 37
Pregunta
When a PC is booting, plug and play makes use of information contained in the ESCD. Where is the ESCD stored?
Respuesta
-
In the northbridge
-
In L1 cache memory
-
In the CMOS
-
In the page file
-
In the memory controller
Pregunta 38
Pregunta
A memory module of DDR2 for desktop PCs is a:
Respuesta
-
SIMM
-
RIMM
-
DIMM
-
CIMM
-
None of these answers
Pregunta 39
Pregunta
You're booting a typical fully functional PC that contains an optical drive and a hard drive. The optical drive is configured as the first boot device in the CMOS setup and there's a non-bootable disc in the optical drive. What will happen?
Respuesta
-
You'll get a "NTLDR missing" error and boot process will halt
-
You'll get a "non-system disk" error and boot process will halt
-
You'll get a "ESCD updating" message and boot process will halt
-
You'll get a "missing command interpreter" error and boot process will halt
-
None of these answers
Pregunta 40
Pregunta
The square four pin power connector that provides power to the processor on modern desktop PCs is called a P4 connector.
Respuesta
- True
- False
¿Quieres crear tus propios Tests gratis con GoConqr? Más información.