Unit 108 Above Ground Drainage

Descripción

Short exam for unit 108
james crowley
Test por james crowley, actualizado hace más de 1 año
james crowley
Creado por james crowley hace más de 4 años
1742
0

Resumen del Recurso

Pregunta 1

Pregunta
List below three common hand tools and their uses for working with waste pipe and rainwater guttering.
Respuesta
  • Multipurpose saw - cutting waste pipe and guttering
  • Plumb Line – setting out a vertical line
  • Chop saw - for cutting pipe
  • Screwdriver – for screws in brackets
  • Wire wool - for deburring edges

Pregunta 2

Pregunta
State two safety requirements when using hand tools whilst fitting gutter and waste pipe
Respuesta
  • Tools must be used per manufacturer’s instructions
  • Tools must be well maintained and in good condition
  • Some PPE must be worn
  • You must start work at 7am

Pregunta 3

Pregunta
State three basic maintenance requirements of common plumbing hand tools.
Respuesta
  • Ensure tools are clean and safe to use
  • Ensure all cutting edges/blades are sharp
  • Ensure all moving parts are well oiled and move easily
  • Ensure you buy new tools

Pregunta 4

Pregunta
Which of the following is the maximum recommended spacing for fascia?
Respuesta
  • a) 0.5m
  • b) 0.75m
  • c) 1.0m
  • d) 1.5m

Pregunta 5

Pregunta
When two pieces of guttering are joined together a gap is left between them. State the reason for this gap. The gap is left to allow the gutter to expand when heated by the outside air temperature.
Respuesta
  • True
  • False

Pregunta 6

Pregunta
The gradient should fall 1:600 when installing rainwater guttering
Respuesta
  • True
  • False

Pregunta 7

Pregunta
The clip in the picture is generally used on which size waste pipe
Respuesta
  • a) 40mm
  • b) 110mm
  • c) 28mm
  • d) 25mm

Pregunta 8

Pregunta
State the size of waste pipe used on a bath
Respuesta
  • 40mm
  • 32mm

Pregunta 9

Pregunta
The clips below are generally used on which of the following size waste pipes
Respuesta
  • a) 32mm
  • b) 23mm
  • c) 46mm
  • d) 119mm

Pregunta 10

Pregunta
40mm diameter vertical waste pipe should have a maximum clipping distance of
Respuesta
  • a) 1m
  • b) 1.2m
  • c) 1.5m
  • d) 1.8m
Mostrar resumen completo Ocultar resumen completo

Similar

How well do you know GoConqr?
Sarah Egan
General Knowledge Quiz
Andrea Leyden
Revision Timetable
katy.lay
OCR Gateway GCSE P3 Revision Quiz
xhallyx
Ancient Roman Quiz
Rev32
The Engineered World - Unit 1
Yachtmasterhammond
How to revise
KimberleyC
Irregular German Verbs
Libby Shaw
Prueba de Funciones
José William Montes Ocampo
Religious Studies Key Concepts
Keera
Java Practice 1
Ummm No