4671012
Descripción
Test por TRAVIS CANNING, actualizado hace más de 1 año
|
Creado por TRAVIS CANNING
hace casi 9 años
|
|
Pregunta 1
Pregunta
A gas turbine compressor is usually
Respuesta
-
centrifugal type
-
downstream of the turbine
-
dynamic axial design
-
downstream of the combustor
-
driven by a motor
Pregunta 2
Pregunta
The compressor on the gas turbine
Respuesta
-
can be driven by the load turbine
-
is always of the axial type
-
is always a multi-staged compressor
-
is always independently driven
-
is always a reciprocating type
Pregunta 3
Pregunta
The combustion chamber of a gas turbine
Respuesta
-
increases the pressure of the compressed air
-
is heated between the load turbine and the compression turbine
-
burns fuel with excess air
-
is water cooled
-
rotates at shaft speed
Pregunta 4
Pregunta
Many typical steam plant auxiliaries are eliminated with a gas turbine due to its
Respuesta
-
small size
-
high speed
-
high power to weight ratio
-
simplicity
-
low oil consumption
Pregunta 5
Pregunta
Gas turbines are very popular where
Respuesta
-
noise does not present a problem
-
water is scarce
-
industrial sites are small and in congested areas
-
thermal pollution is of major concern
-
natural gas is plentiful
Pregunta 6
Pregunta
gas turbines are ideal when considering
Respuesta
-
long warm-up periods
-
emergency power generation
-
automotive power
-
cooling water pump operation
-
good thermal efficiency
Pregunta 7
Pregunta
A two shaft gas turbine
Respuesta
-
has the load turbine downstream from the compressor turbine
-
has the first turbine drive the prop on a turbo-prop engine
-
is always an open cycle type
-
is always a closed cycle type
-
does not require a starting motor
Pregunta 8
Pregunta
A gas turbine is not self-starting. It must be rotated at _________ of its maximum speed before fuel is turned on
Respuesta
-
10% to 30 %
-
15% to 30 %
-
20% to 30 %
-
25% to 30 %
-
25% to 50%
Pregunta 9
Pregunta
Early gas turbines were handicapped by
Respuesta
-
metal not being able to withstand high speed centrifugal forces
-
the inability to get enough air into the combustion chamber
-
metals not standing the high temperatures involved
-
their high operating speeds
-
their inadequate power capability
Pregunta 10
Pregunta
The temperature to which the air can be raised at the turbine inlet is
Respuesta
-
an indication of a units power
-
directly related to the units size
-
a function of the air compressor input
-
an indication of the units efficiency
-
important for proper compressor performance
Pregunta 11
Pregunta
The low installation cost of a gas turbine is
Respuesta
-
due to cheap materials in the blades
-
due to short fuel lines
-
because no fuel pump is required
-
because no electrical wiring is required
-
because less auxillary equipment is needed
¿Quieres crear tus propios Tests gratis con GoConqr? Más información.