Pregunta 1
Pregunta
The maximum supply voltage shall not exceed ______ between conductors unless otherwise permitted.
Respuesta
-
300 Volts
-
600 Volts
-
800 Volts
-
1000 Volts
Pregunta 2
Pregunta
The first edition of the 17.1 code was published in what year?
Pregunta 3
Pregunta
What Section of NFPA 70 pertains to Elevators, Dumbwaiters, Escalators, Moving Walks, Platform Lifts, and Stairway Chairlifts?
Pregunta 4
Pregunta
Each 125-volt, single-phase, 15- and 20-ampere receptacle installed in pits, in hoistways, on elevator car tops, and in escalator and moving walk wellways shall be of the _____________________________type.
Pregunta 5
Pregunta
Per NFPA 70, Ground means:
Respuesta
-
Conductors connected to close an open circuit.
-
Earth.
-
A 5/8's copper rod fully driven in the ground.
-
A 4/0 or larger conductor attached from the supply source to a ground rod.
Pregunta 6
Pregunta
To whom is the maintenance control program required to be accessible?
Pregunta 7
Pregunta
Final Terminal Stopping Devices for Screw-Elevators shall be provided for elevators having a rated speed exceeding:
Respuesta
-
0.5m/s (100 ft/min)
-
150 ft/,min
-
0.05m/s (100ft/min)
-
0.6m/s (120ft/min)
Pregunta 8
Pregunta
Which of the following should you do when operating a mainline power disconnect switch?
Respuesta
-
Reach across the front of the disconnect while facing away from the disconnect
-
Stand in front of the disconnect with you back to the disconnect.
-
Stand off to the side of the disconnect
-
Ensure that you are standing on a rubber mat
Pregunta 9
Pregunta
What article in NEC 2014 covers hazardous (classified ) locations?
Pregunta 10
Pregunta
For existing elevator interiors, what is the minimum number of lamps required for car illumination?
Pregunta 11
Pregunta
What is required of a maintenance control program?
Pregunta 12
Pregunta
The audible and visual equipment such as chimes, gongs, lights and displays that convey information to the user is defined as what?
Respuesta
-
operating device
-
control system
-
signal equipment
-
controller operation
Pregunta 13
Pregunta
When performing maintenance on an escalator, what is required if the escalator comb has two adjacent teeth missing?
Respuesta
-
The AHJ must be notified
-
The emergency stop button should be pushed
-
The unit may be operated only in the direction away from the combplate
-
The escalator must be removed from service
Pregunta 14
Pregunta
Speed governors for passenger car safeties shall be set to trip at a car speed of what?
Respuesta
-
Not less than 110% of rated speed
-
Not less than 112% of rated speed
-
Not less than 115% of rated speed
-
not less than 125% of rated speed
Pregunta 15
Pregunta
When jumpers are used during maintenance, repairs, or testing, all jumpers shall be ______________ and the equipment ______________ prior to returning it to service.
Respuesta
-
removed / tested
-
jumped / shut off
-
shorted / fried
-
unhooked / looked at
Pregunta 16
Pregunta
The lower portion of a platform guard shall be bent back at an angle of not less than __________degrees nor more than _______ degrees from the horizontal.
Respuesta
-
25 and 50
-
45 and 75
-
60 and 80
-
60 and 75
Pregunta 17
Pregunta
Every elevator shall be provided with a _________________ and a _________________ permanently and securely attached.
Respuesta
-
capacity plate / data plate
-
capacity plate / dinner plate
-
lounge chair / ash tray
-
capacity sticker / data sticker
Pregunta 18
Pregunta
Hand elevator suspension means shall consist of not less than ______ wire ropes or chains.
Pregunta 19
Pregunta
____________ shall be provided in the entrance assembly to prevent hangers from overrunning the end of the track.
Respuesta
-
Free Coffee
-
pins
-
buffers
-
stops
Pregunta 20
Pregunta
What type of floor shall be provided at the top of the hoistway where a machine room or control room is located above the hoistway.
Respuesta
-
Metal or Concrete
-
Wood or drywall
-
fireproof
-
flameproof