GCSE Physics: Electrical Energy

Descripción

GCSE Physics: Electrical Energy
Landon Valencia
Diapositivas por Landon Valencia , actualizado hace más de 1 año
Landon Valencia
Creado por Landon Valencia hace más de 9 años
225
0

Resumen del Recurso

Diapositiva 1

    Electrical Heating
    Many electrical appliances used at home are lamps or heaters. In a lamp, electrical energy is transferred as light and heat.There are different types of lamps, including: tungsten filament lamps discharge tube lamps Filament lampsIn a tungsten filament lamp the energy is transferred in the resistance wire which makes up the filament. If you look at it closely, you will see the filament glowing but it also gives off a lot of heat. Of the electrical energy that goes into the lamp as little as 10% is transferred as light and up to 90% as heat.An electric heater operates in the same way as a filament lamp in that the energy is transferred (from electrical to heat in this case) in a resistance wire, often called the element.
    Pie de foto: : Tungsten Filament Lamp

Diapositiva 2

    Tube lamps
    In a discharge tube the energy is transferred in the gas inside the tube.A discharge tube lamp is more efficient than a filament lamp because: more of the electrical energy is transferred as light less of the electrical energy is transferred as heat

Diapositiva 3

    Electrical Energy
    For a given amount of electrical charge that moves, the amount of energy transferred increases as the potential difference increases.Calculating energy transferredWork out the energy transferred using this equation:Energy = current × voltage × timeE = I × V × twhere: E is the energy transferred in joules, J I is the current in amperes, A V is the potential differences in volts, V t is the time in seconds, s

Diapositiva 4

    Electricity meters measure the number of units of electricity used in a home or other building. The more units used, the greater the cost. The cost of the electricity used is calculated using this equation:Total Cost = number of units × cost per unitFor example, if 5 units of electricity are used at a cost of 8p per unit, the total cost will be 5 × 8 = 40p.Remember that the number of units used can be calculated using this equation:Units (kWh) = power (kW) × time (h)Total cost = power (kW) × time (h) × cost per unit
    Cost of Electricity
Mostrar resumen completo Ocultar resumen completo

Similar

GCSE AQA Physics - Unit 3
James Jolliffe
GCSE AQA Physics 1 Energy & Efficiency
Lilac Potato
P2 Radioactivity and Stars
dfreeman
Physics 1A - Energy
Zaki Rizvi
Physics: Energy resources and energy transfer
katgads
P2a revision (part 1)
juliasutton
P2a (part 2)
juliasutton
Renewable Energy Sources
darkangelforgiven
P3 Medical Applications of Physics
dfreeman
Forces and motion
Catarina Borges