Project Ideas

Centre Lathe with a Haxsaw attached to the toolpost
1. Parting tool is good enough.
  1. I would improve it.
    1. I'd change the haxsaw design like a circular saw in comparison to a Traditional Haxsaw.
      1. Lowers the mechanical attribute of a Traditional Haxsaw movement on a tool post for a spinning action.
Centre Lathe with a File attached to the toolpost
1. Emory Cloth/File is good enough
2. It would be faster than a parting off tool
3. You might aswell hold a file up to a lathe
  1. However it is more precise because it would be done robotically
Portable Phone charger
1. Cheaper than Buying one
2. It's not an original concept.
  1. I would improve it
    1. Decreasing it's size for portability
      1. However with more batteries. The larger the size and overall decreasing portablity.
    2. Increasing the batteries capacity (ie. More AA batteries)
Project Furnace Square
1. Dangerous to untrained personel
2. Melts down common waste products

Resumen del Recurso

	Creado por Rory Pagett hace casi 9 años