Which device distributes heat via duct work through registers

What is installed directly in up flow vertical duct, or plenum that is intended to be the primary source of heat

Which section of the CEC deals with installation of heating units?

Temperature is a measure of

A BTU is

Heat transferred by electromagnetic wave motion by which we receive heat from the sun is through?

The heat exchanger is a

What is usually provided on the intake side of the fan in the return air system?

The function of the refrigeration cycle is to

Air conditioners and heat pumps cool a home by

Which part of the HVAC system is responsible for compressing the Freon

This type of compressor is completely sealed inside a metal housing and is not serviceable

If the load on the evaporator changes, what type of valve can respond to the change and increase or decrease the flow accordingly

What is a fluid that changes readily from a liquid to a vapour or from a vapour to a liquid?

A conventional condenser unit requires a liquid refrigerant which is also called?

What is the refrigerant state when it is going towards the condenser?

Which component pushes the hot gas to the finned condenser coil in the outdoor side of the air conditioner

Two different pressures exist in the refrigeration cycle. The two components that separate the high-pressure side from the low-pressure side are

In the cooling mode, what component is located inside the building?

This law states that heat always from from a higher temperature to a lower temperature

The amount of heat added to the liquid to make it saturated and change states is called?

Heat, that when added or removed, causes a change in temperature but not in state

Refrigerant lines are usually made from

What type of vents are usually used which can handle a wide range of temperatures?