Com/Nav CDC test 1

1

The AFI that governs the current wing organization and operation is

1

Who is responsible for directing the maintenance effort using available resources and participating in the development and execution of the monthly, weekly flying and maintenance schedules/plans?

1

What flight in the maintenance squadron primarily performs off-equipment maintenance of avionics components and electronic warfare systems?

1

Informational publications that include procedures for implementing Air Force policies are called

1

If you need to tie together all maintenance actions on a specific job, which MDC system data element do you use?

1

The number entered in the TAG NUMBER block of AFTO Form 349 comes from

1

What block of AFTO Form 349 is checked to indicate actions that affect the historical records of an end-item?

1

The IMDS is event oriented and user friendly, which means that it

1

Which is not a function of the G081 Automated Maintenance Information System?

1

One of the basic principles of supply discipline is to

1

One way you can be relieved of property responsibility is to

1

How does the deficiency reporting system reduce total ownership cost?

1

The TO numbering system is explained in detail in TO

1

Which Air Force technical manuals contain data for the operation and servicing of aircraft equipment?

1

Which index lists all Air Force MPTOs?

1

Before an AFTO Form 22 is submitted, the submitter’s supervisor assesses it in terms of mission impact, personnel and system safety, and

1

A GS manual provides

1

The ACPINS provides a standardized system that performs all of the tasks listed below except

1

How many CPIN identifier fields are there?

1

Which security classification guide section would list the transmit frequency of an electronic warfare system?

1

What structural areas allow maintenance personnel to inspect or service aircraft components?

1

Which is not an offensive avionics system?

1

What is the minimum safe distance from an UHF antenna when the associated transmitter is radiating power?

1

Which is a condition that results from frequent exposure to small overdoses of noise?

1

Which inspection is more extensive than the hourly postflight or basic postflight inspections and covers certain parts, areas, and systems of the aircraft that require less frequent inspection?

1

The AFTO Form 781-series would not be used to document aircraft

1

Who is responsible for the validity and legibility of all COMSEC required entries?

1

To “flag” a condition on an aircraft that could cause damage or injury if ignored, use

1

Which is not a flight line precaution used to protect ESDS components?

1

Which is not a type of connector coupling?

1

Utilizing exact dimensions for stripping wire ensures

1

One purpose of crimper positioners is to

1

As a flight line technician, you can repair up to

1

The circuit used in an AM transmitter to bring the oscillator frequency up to the designed frequency required for carrier wave operation is

1

In an FM transmitter, the frequency of the oscillator is controlled by the

1

In single sideband transmitter, the balanced modulator’s output consists of

1

The purpose of the limiter circuit in an FM receiver is to

1

A receiving radio antenna receives radio frequency signals by

1

The primary reason the high-frequency radio uses single sideband modulation is

1

You are using a learned preset for the ARC–190 high-frequency radio system. For this application, the transmit tune time is less than

1

Which very-high frequency radio system uses two antennas?

1

The Have Quick II frequency-hopping pattern and rate is programmed by the

1

What LRU provides primary control of the ARC–210 radio system?

1

How do you swap the active and standby frequencies of the ARC–210 radio system using the remote tuning panel?

1

Which one of the following is not an operating mode of the PRC–90 emergency radio?

1

When activated, the emergency locator transmitter continuously transmits on frequencies

1

The purpose of the +17 to +29 VDC on the CALL control line of the C–6567 is to

1

The major difference between the U–92A/U and the U–94A/U jack is the

1

The forward external interphone receptacle in the airborne digital interphone system (ADIS) system allows the operator to transmit on a radio, even though the other two external receptacles cannot, because it is connected to the

1

If you need to store 12 cryptographic keys, then how many KYK–13 devices will you require?

1

Why does the KYK–13 parity light flash on and off continuously?

1

What KY–58 line replaceable unit (LRU) has the primary function of transmitting and receiving secure voice messages?

1

Parallels of latitude are parallel to the

1

Which global positioning system unit in the ARN–151 produces the intermediate frequency signal?

1

In the tactical air navigation (TACAN) receiver transmitter (RT) adapter, TO/FROM information is developed by combining magnetic bearing with

1

If an aircraft is flying inbound on the 90° radial of a very-high frequency omnirange (VOR) station, then what will be the outbound radial when the aircraft passes the station?

1

When the IDENT-OUT-MIC switch is in the MIC position, identification, friend or foe (IFF) identification of position (I/P) replies are triggered every time which radio system is keyed?

1

How long in μs does it take an RF wave to travel a radar mile?

1

Which component in a pulse-modulation radar system shapes the radio frequency energy into a narrow beam?

1

Which of the following are types of power loss in radio frequency lines?

1

Which component in the AN/APN–59 radar system furnishes both pitch and roll drive signals to the antenna stabilization motors?

1

During the CARA radar altitude indicator’s bright lighting conditions, the ambient light sensor serves to

1

Which radar application sends data to compute time-to-go parameters?

1

The elapsed time indicator of the R/T indicates the time power has been

1

What is the range in MHz of signals that the low pass filter passes?

1

If the JTIDS entrant is attempting to achieve fine synchronization by transmitting a round trip time interrogation, then what process is being used?

1

What is the structure of a MIL-STD1553 data word?

1

What part of a computer acts like a sophisticated switchboard operator?

1

The resolution of a computer monitor is expressed in the number of pixels that make up the image; therefore, the sharper the image, the

1

The power meter is used to measure

1

If you want to measure relative power using a power meter, you would first apply the power level and then press

1

Before power is connected to the RFLTS, you must ensure the ON/POWER/OFF switch is in the OFF position and a suitable grounding strap is connected between the grounding lug on the right side of RFTLTS unit 1 and the

1

When using the 1 and 3 milliohm range on the model 4328A millohmeter, how far away from the conducting surface should the probes and cables be placed?

1

What basic function of a data bus analyzer provides the ability to introduce an error condition into the data to permit an analysis of how the system will behave?

1

When the confidence test is performed, which APX–64 transponder R/T module’s gain is increased?

1

When pressing the TEST RPT button on the transponder TS–3977 test set while aiming the antenna at the ground, the test code indication should be

1

If you turn the Bearing CW/CCW switch on the ARM–184 flightline test set, then the indicator should increase or decrease at an angular rate of

1

Traditional noise jamming techniques designed to block communications channels or radarscope presentations are applications of

1

Electronic support data is not used to produce

1

Normal suppression of enemy air defense targets include radars for

1

What Air Force aircraft is used to perform the Wild Weasel mission?

1

A repeater jamming technique that copies enemy radar pulses and returns incorrect target information to the enemy radar is an example of

1

What are electronic warfare (EW) reconnaissance crews called?

1

What electronic intelligence (ELINT) equipment is used to determine the location of emitters?

1

What radar display indicator displays range or velocity?

1

The radar warning receiver (RWR) does not provide signal

1

What infrared (IR) detector device requires a bias current or voltage to operate?

1

What infrared (IR) seeker uses many detectors and each one detects a small portion of a scene?

1

In what frequency region do the missile approach warning systems (MAWS) operate?

1

When a photon causes the release of another photon, it is called

1

What is not a battlefield usage of the laser?

1

What technology does the Pilot Alert System (PAS) employ to detect contrail from the #3 engine exhaust?

1

The chaff tactic that dispenses large quantities of chaff in a continuous ribbon is called

1

A typical flare cartridge is composed of magnesium and tetraflouroethylene and burns at

1

What indicates the relative signal strength of the received radio frequency (RF) signal?

1

The four control modes allow you to vary the output

1

What test equipment is used to check the aircraft expendables (chaff and flare) systems?

1

What describes in detail how an Electronic Warfare Integrated Reprogramming (EWIR) change affects an Electronic Warfare (EW) system?

1

Which of the following is an Air Force reprogramming exercise?

1

What countermeasures dispenser tester (CDT) functional check measures the firing pulse amplitude and pulse duration?