Annette Castillo
Test por , creado hace más de 1 año

Test sobre CCNP Route V6 Final Exam, creado por Annette Castillo el 26/06/2015.

21
0
0
Annette Castillo
Creado por Annette Castillo hace más de 9 años
Cerrar

CCNP Route V6 Final Exam

Pregunta 1 de 8

1

How do EIGRP routers establish and maintain neighbor relationships?

Selecciona una de las siguientes respuestas posibles:

  • by exchanging neighbor tables with directly attached routers

  • by comparing known routes to information received in updates

  • by exchanging hello packets with neighboring routers

  • by dynamically learning new routes from neighbors

  • by exchanging routing tables with directly attached routers

Explicación

Pregunta 2 de 8

1

The IPv6 autoconfiguration feature enables a PC to automatically connect to an IPv6 network. What type of IPv6 address allows a PC
host to send a router solicitation message requesting a prefix for stateless autoconfiguration?

Selecciona una de las siguientes respuestas posibles:

  • link local address

  • site local address

  • aggregatable global unicast address

  • loopback address

  • IPv4-compatible address

  • flow-label address

Explicación

Pregunta 3 de 8

1

During an interview, the company IT manager mentions that the company has two critical communication links to its main supplier.
These links require an uptime of 24/7. Which part of the PPDIOO process is most affected by this information?

Selecciona una de las siguientes respuestas posibles:

  • design phase

  • implementation phase

  • routing protocol selection

  • prototype design plan

Explicación

Pregunta 4 de 8

1

Refer to the exhibit. The RIP routes must be injected into the OSPF domain. Which command will perform external route
summarization?

Selecciona una de las siguientes respuestas posibles:

  • RTB(config-router)# summary-address 192.168.16.0 255.255.252.0

  • RTA(config-router)# summary-address 172.20.0.0 255.255.0.0

  • RTB(config-router)# area 1 range 192.168.16.0 255.255.252.0

  • RTA(config-router)# area 1 range 172.20.0.0 255.255.0.0

Explicación

Pregunta 5 de 8

1

Refer to the exhibit.
access-list 111 permit ip 10.0.0.0 0.255.255.255 any
route-map net-10 permit 10
match ip address 111
set interface FastEthernet 0/1
Where would the system administrator apply the above configuration to establish policy-based routing that directs packets from the
10.0.0.0/8 network through the R2 router to the Internet?

Selecciona una de las siguientes respuestas posibles:

  • RTA interface Fa 0/0

  • RTA interface Fa 0/1

  • RTB interface Fa 0/1

  • RTB interface Fa 1/0

  • R2 interface Fa 0/0

  • R2 interface Fa 0/1

Explicación

Pregunta 6 de 8

1

How does OSPF exchange routing updates when the passive-interface command is applied?

Selecciona una de las siguientes respuestas posibles:

  • OSPF forms neighbor adjacencies on that interface.

  • The OSPF interface enters an active state.

  • OSPF stops sending routing updates out that interface.

  • OSPF only receives routing updates on that interface.

  • OSPF neither sends nor receives routing updates through that interface.

Explicación

Pregunta 7 de 8

1

Which functional component of the Cisco Enterprise Architecture is responsible for hosting internal servers?

Selecciona una de las siguientes respuestas posibles:

  • enterprise edge

  • enterprise campus

  • service provider edge

  • building distribution

Explicación

Pregunta 8 de 8

1

Refer to the exhibit. A network administrator has configured EIGRP authentication between routers R1 and R2. After the routing tables
are reviewed, it is noted that neither router is receiving EIGRP updates. What is a possible cause for this failure?

Selecciona una de las siguientes respuestas posibles:

  • The same number of key strings must be used on each router.

  • The same key chain name must be used on each router.

  • The same autonomous system numbers must be used in the interface configurations of each router.

  • The authentication configuration is correct, but the show ip eigrp neighbors command should be issued to troubleshoot the issue.

Explicación