|
Creado por Joey Higgins
hace alrededor de 3 años
|
|
Cutter Comp Cancel
Rapid Traverse Motion
Spindle Stop
Linear Interpolation Motion
Circular Interpolation Motion,
Clockwise
Tool Change
Absolute Programming Positioning
Circular Interpolation Motion,
Counter-Clockwise
Cutter Comp RIGHT of programmed path
Subprogram Call
Tool Length Compensation +
Work Coordinate #1 (Part Zero Offset)
Canned Cycle Cancel
Coolant ON Command
Drill Canned Cycle
Tapping Canned Cycle
Incremental Programming Positioning
Canned Cycle Rapid Plane Return
The _____ code is used for a Program Stop command on the machine. It stops the spindle, turns off coolant and stops look-ahead processing. Pressing CYCLE START again will continue the program on the next block of the program.
Spindle Start Clockwise
Spindle Start Counter-Clockwise
Coolant OFF Command
Program End and Reset to beginning of program
Local Subroutine Call
Subprogram Return (M98) or Subroutine Return (M97), or a Program loop
Cutter Compensation LEFT of the programmed path
Machine Home (Rapid Traverse)
Spot Drill Canned Cycle
The ____ code is used for an Optional Program Stop command. Pressing the OPT STOP key on the control panel signals the machine to perform a stop command when the control reads an ____ command. It will then perform like an M00.
Peck Drill Canned Cycle
Machine Coordinate Positioning, Non-Modal
Canned Cycle Initial Point Return
