Which brick manufacturing process is characterized by extruding rigid clay that has a moisture content of 12% to 15% through a die and by cutting the extrusion to length before firing?
Soft-mud process
Dry-press process
Stiff-mud process
Hard-cut process
If a given project is organized per the 2018 CSI MasterFormat, where would you most likely find the specifications for a grey-water pump?
Division 22
Division 23
Division 26
None of the above
According to the 2018 IBC, which of the following is a Class C material?
Flame spread index - 23, Smoke-developed index - 350
Flame spread index - 95, Smoke-developed index - 25
Flame spread index - 74, Smoke-developed index - 400
Flame spread index - 67, Smoke-developed index - 50
Per the 2018 CSI MasterFormat, which division is not represented in any of the callouts from the section shown below?
Division 04
Division 09
Division 05
Division 07
A given client wants to build a new house with double-wythe brick exterior walls. The architect specified a brick type for the exterior wythe that is characterized by having a minimum variation in size, color range and has the highest uniformity in size. Which type of brick did the architect choose?
FBX
FBA
FBS
FBY
Consider a meeting room measuring 32 ft x 28 ft. It has been determined that the desired illuminance is 37 lumens/sf and that a total number of 23 light fixtures will be installed in a grid pattern. Assuming a CU of .68 and a LLF of .79, what is the total luminous flux of each light fixture?
Per the lumen method: Nr. of fixtures = Foot-candles x Floor area / Lumens x CU x LLF
1,435
1,968
2,683
3,457
Per the US National CAD Standard, how should a door be annotated in a plan?
Text enclosed in an elongated circle
Text enclosed in a square
Text enclosed in a circle
Text enclosed in a triangle
Which wood joint is represented in the image below?
Finger joint
Dado and rabbet joint
Scarf joint
Tongued miter joint
Which diagram correctly represents a fixed beam at one end and supported at the other, where the load is concentrated at any point?
Diagram A
Diagram B
Diagram C
Diagram D
What type of door is shown in the image?
Swing door
Dutch door
Revolving door
Balanced door
What would be more appropriate to use at an interior corner of two walls with a plaster finish?
Corner bead
F-reveal trim
Corner lath
Casing bead
17 Lux equals exactly how many Lumens?
170 Lumens/sf
17 Lumens/m²
17 Lumens/sf
17 Lumens/ft
Which duct section is most efficient at carrying air?
Square
Circular
Oval
Rectangular
What is the maximum recommended spacing between vertical studs supporting a gypsum board finish with a thickness of ½”?
12"
16"
24"
32"
Which of the following mortar joints are not represented in the image below? Select two.
Concave
Ruled
Grapevine
V shaped
Struck
Weathered
According to the 2018 IBC, what dimension is primarily used to determine the fire resistance of a concrete masonry unit?
Total width
Nominal width
Type of aggregate
Equivalent thickness
Which fixture usually requires the highest minimum operating pressure?
Shower
Lavatory faucet
Dishwasher
Bathtub faucet
If a given project is organized per the 2018 CSI MasterFormat, where would you most likely find the specifications for an electric boiler?
Division 11
Generally speaking, how should an architect dimension a set of plans?
Include as many as possible
Provide only the essential ones
Include as few as possible
Provide all dimensions
Which type of backflow preventer would be more appropriate to use in a high hazard situation?
Reduced-pressure zone
Double check valve
Vacuum breaker
Air Gap
Por favor espera - en proceso…