2W151 Volume I: Administration, Management, and Publications - Quiz 5

Which technical orders (TO) are prepared in limited quantities to test and verify certain procedures developed with the first test or early production models of some missiles, aircraft, or ground support equipment?

Which kind of time compliance technical order (TCTO) will be issued if a condition exists which if left uncorrected, could result in fatal or serious injury to personnel or extensive damage or destruction to property?

In which publication would you find information or the change or revision status of a technical order?

Which technical orders are primarily work simplification devices to help personnel carry out instructions contained in other type of technical orders?

In TO 1F-16C-33-1-2, the designator "1F" identifies the:

Which publication list major technical order indexes by category?

How are changed pages in printed technical orders identified?

Which publication is issued for a technical order that contains material that is not part of the normal sequence outlined in the table of content?

Which term identifies completely new editions of a publication that bear a new publication date?

Which technical order deficiency report identifies a deficiency that affects safety and the unit mission?

Which TO deficiency report identifies recommended TO improvements, which if not made, will create potentially hazardous conditions through continued use and will have a negative effect on operation, maintenance efficiency, or on the operating life or general service use of the equipment?

How does the user typically generate a technical order change request to change an integrated electronic manual?

How many TCTOs are there?

Which of the following TCTOs are issued because conditions could result in injury to personnel, damage to valuable property or unacceptable reductions in combat efficiency.

This type of TO is in the form of a tape or a card.

Where do you access an Interactive Electronic Technical Manual?

In the TO 1F-16C-2-94JG-30-1, what does the third group identify?

In the TO 1F-16C-2-94JG-30-1, what does the fourth group identify?

In the TO 1F-16C-2-94JG-30-1, what does the second group identify?

This type of TO are issued as separate publications incorporating augmented or revised data.

How many deficiency reports are there?

This type of deficiency report recommend non-emergency correction to TO deficiency involving hazardous conditions. If not corrected, the deficiency can result in injury to people, damage to equipment or property, or reduce operating efficiency.