Brian Gamble
Test por , creado hace más de 1 año

CCNA (Chapter 10) ICND2 Test sobre ICND2 Ch 10 quiz, creado por Brian Gamble el 03/02/2016.

7
0
0
Brian Gamble
Creado por Brian Gamble hace casi 9 años
Cerrar

ICND2 Ch 10 quiz

Pregunta 1 de 8

1

A classful network in which packets sent between at least one pair of subnets must pass through subnets of a different classful network.

Selecciona una de las siguientes respuestas posibles:

  • Contiguous

  • Discontiguous

Explicación

Pregunta 2 de 8

1

A classful network in which packets sent between every pair of subnets can pass only through subnets of that same classful network, without having to pass through subnets of any other classful network.

Selecciona una de las siguientes respuestas posibles:

  • Contiguous

  • Discontiguous

Explicación

Pregunta 3 de 8

1

What is Step 2 for EIGRP configuration?

Selecciona una de las siguientes respuestas posibles:

  • Impact metric calculations by tuning bandwidth and delay using the bandwidth value and delay value interface subcommand.

  • Set the EIGRP router ID (RID) explicitly with the eigrp router-id value router subcommand

  • Enter configuration mode and define the EIGRP autonomous system number (ASN) by using the router eigrp as-number global command.

  • Configure one or more network ip-address [wildcard-mask] router subcommands. This enables the EIGRP on any matched interface and causes EIGRP to advertise the connected subnet.

Explicación

Pregunta 4 de 8

1

Routes that are neither successor nor FS can never be added to the IP routing table regardless of the varianc e setting, because doing so may cause packets to loop.

Selecciona uno de los siguientes:

  • VERDADERO
  • FALSO

Explicación

Pregunta 5 de 8

1

R2 has two routes to network 10.0.0.0/8: one pointing left toward R1 and one pointing right toward R3. R2 simply uses its usual load-balancing logic, because as far as R2 can tell the two routes are simply equal-cost routes to the same destination: the entire network 10.0.0.0. Sometimes R2 happens to forward a packet toward the correct destination, and sometimes not. This problem has two solutions; what are they?

Selecciona una o más de las siguientes respuestas posibles:

  • Create IP addressing plans that do not create discontiguous classful networks

  • Use autosummary by using EIGRP defaults

  • Create IP addressing plans that create discontiguous classful
    networks

  • Do not use autosummary by using EIGRP defaults

Explicación

Pregunta 6 de 8

1

The only difference compared to OSPF is that the EIGRP RID is configured with the __________________ router subcommand, whereas OSPF uses the router-id value subcommand.

Selecciona una de las siguientes respuestas posibles:

  • Router eigrp

  • Eigrp router-id value

  • Show ip route eigrp

  • none of these

Explicación

Pregunta 7 de 8

1

What is the report distance (RD)?

Selecciona una de las siguientes respuestas posibles:

  • What is the report distance (RD)?

  • The metric of the best route to reach a subnet

  • The result of the calculation of the EIGRP metric for a route

  • The metric calculated from the perspective of the next-hop router

Explicación

Pregunta 8 de 8

1

In real networks, most people prefer to use autosummary today

Selecciona uno de los siguientes:

  • VERDADERO
  • FALSO

Explicación

Anterior
Siguiente