Brian Gamble
Test por , creado hace más de 1 año

Final / Review ICND 1 Test sobre DIKTA ICND 1 Ch 15, creado por Brian Gamble el 03/03/2016.

42
0
0
Brian Gamble
Creado por Brian Gamble hace más de 8 años
Cerrar

DIKTA ICND 1 Ch 15

Pregunta 1 de 6

1

Which of the following installation steps are typically required on a Cisco router, but not typically required on a Cisco switch? (Choose two answers.)

Selecciona una o más de las siguientes respuestas posibles:

  • Connect Ethernet cables

  • Connect serial cables

  • Connect to the console port

  • Connect the power cable

  • Turn the on/off switch to “on”

Explicación

Pregunta 2 de 6

1

Which of the following commands might you see associated with the router CLI, but not with the switch CLI?

Selecciona una de las siguientes respuestas posibles:

  • The clock rate command

  • The ip address address mask command

  • The ip address dhcp command

  • The interface vlan 1command

Explicación

Pregunta 3 de 6

1

You just bought two Cisco routers for use in a lab, connecting each router to a different LAN switch with their Fa0/0 interfaces. You also connected the two routers’ serial interfaces using a back-to-back cable. Which of the following steps are not required to be able to forward IPv4 packets on both routers’ interfaces? (Choose two answers.)

Selecciona una o más de las siguientes respuestas posibles:

  • Configuring an IP address on each router’s Fast Ethernet and serial interfaces

  • Configuring the bandwidth command on one router’s serial interface

  • Configuring the clock rate command on one router’s serial interface

  • Setting the interface description on both the Fast Ethernet and serial interface of each router

Explicación

Pregunta 4 de 6

1

The output of the show ip interface brief command on R1 lists interface status codes of “down” and “down” for interface Serial 0/0. Which of the following could be true?

Selecciona una de las siguientes respuestas posibles:

  • The shutdown command is currently configured for that interface

  • R1’s serial interface has been configured to use Frame Relay, but the router on the other end of the serial link has been configured to use PPP.

  • R1’s serial interface does not have a serial cable installed.

  • Both routers have been cabled to a working serial link (CSU/DSUs included), but only one router has been configured with an IP address.

Explicación

Pregunta 5 de 6

1

Which of the following commands do not list the IP address and mask of at least one interface? (Choose two answers.)

Selecciona una o más de las siguientes respuestas posibles:

  • show running-config

  • show protocols type number

  • show ip interface brief

  • show interfaces

  • show version

Explicación

Pregunta 6 de 6

1

Which of the following is different on the Cisco switch CLI as compared with the Cisco router CLI?

Selecciona una de las siguientes respuestas posibles:

  • The commands used to configure simple password checking for the console

  • The number of IP addresses configured

  • The configuration of the device’s host name

  • The configuration of an interface description

Explicación

Anterior
Siguiente