Brian Gamble
Test por , creado hace más de 1 año

Final / Review ICND 1 Test sobre DIKTA ICND 1 Ch 16, creado por Brian Gamble el 03/03/2016.

32
0
0
Brian Gamble
Creado por Brian Gamble hace más de 8 años
Cerrar

DIKTA ICND 1 Ch 16

DIKTA ICND 1 Ch 16

Pregunta 1 de 7

1

A PC opens a command prompt and uses the ipconfig command to see that the PC’s IP address and mask are 192.168.4.77 and 255.255.255.224. The user then runs a test using the ping 192.168.4.117command. Which of the following answers is the most likely to happen?

Selecciona una de las siguientes respuestas posibles:

  • The PC sends packets directly to the host with address 192.168.4.117.

  • The PC sends packets to its default gateway.

  • The PC sends a DNS query for 192.168.4.117.

  • The PC sends an ARP looking for the MAC address of the DHCP server.

Explicación

Pregunta 2 de 7

1

Router R1 lists a route in its routing table. Which of the following answers list a fact from a route, that the router then compares to the packet’s destination address? (Choose 2 answers.)

Selecciona una o más de las siguientes respuestas posibles:

  • Mask

  • Next-hop router

  • Subnet ID

  • Outgoing interface

Explicación

Pregunta 3 de 7

1

Router 1 has a Fast Ethernet interface 0/0 with IP address 10.1.1.1. The interface is connected to a switch. This connection is then migrated to use 802.1Q trunking. Which of the following commands could be part of a valid configuration for Router 1’s Fa0/0 interface? (Choose two answers.)

Selecciona una o más de las siguientes respuestas posibles:

  • interface fastethernet 0/0.4

  • dot1q enable

  • dot1q enable 4

  • trunking enable

  • trunking enable 4

  • encapsulation dot1q 4

Explicación

Pregunta 4 de 7

1

A router is configured with the no ip subnet-zero global configuration command. Which of the following interface subcommands would not be accepted by this router?

Selecciona una de las siguientes respuestas posibles:

  • ip address 10.1.1.1 255.255.255.0

  • ip address 10.0.0.129 255.255.255.128

  • ip address 10.1.2.2 255.254.0.0

  • ip address 10.0.0.5 255.255.255.252

Explicación

Pregunta 5 de 7

1

A Layer 3 switch has been configured to route IP packets between VLANs 1, 2, and 3, which connect to subnets 172.20.1.0/25, 172.20.2.0/25, and 172.20.3.0/25, respectively. The engineer issues a show ip route command on the Layer 3 switch, listing the connected routes. Which of the following answers lists a piece of information that should be in at least one of the routes?

Selecciona una de las siguientes respuestas posibles:

  • Interface Gigabit Ethernet 0/0.3

  • Next-hop router 172.20.4.1

  • Interface VLAN 2

  • Mask 255.255.255.0

Explicación

Pregunta 6 de 7

1

An engineer configures a static IPv4 route on Router R1. Which of the following pieces of information should not be listed as a parameter in the configuration command that creates this static IPv4 route?

Selecciona una de las siguientes respuestas posibles:

  • The destination subnet’s subnet ID

  • The next-hop router’s IP address

  • The next-hop router’s neighboring interface

  • The subnet mask

Explicación

Pregunta 7 de 7

1

Which of the following commands correctly configures a static route?

Selecciona una de las siguientes respuestas posibles:

  • ip route 10.1.3.0 255.255.255.0 10.1.130.253

  • ip route 10.1.3.0 serial 0

  • ip route 10.1.3.0 /24 10.1.130.253

  • ip route 10.1.3.0 /24 serial 0

Explicación

Anterior
Siguiente