39481878
Descrição
FlashCards por Edward Guthrie, atualizado 7 meses atrás
|
Criado por Edward Guthrie
7 meses atrás
|
|
| Questão | Responda |
| G00 | Positioning at rapid speed |
| G01 | Linear interpolation |
| G02 | Circular interpolation CW |
| G03 | Circular interpolation CCW |
| G04 | Dwell |
| G09 | Exact Stop |
| G10 | Setting offsets in the program |
| G12 | Circular Pocket Milling CW (Mill) |
| G13 | Circular Pocket Milling CCW (Mill) |
| G17 | X-Y plane for arc machining |
| G18 | Z-X plane for arc machining |
| G19 | Z-Y plane for arc machining |
| G20 | Inch Units |
| G21 | Metric Units |
| G27 | Reference return check |
| G28 | Automatic return through reference point |
| G29 | Move to location through reference point |
| G31 | Skip functioning |
| G32 | Thread cutting (Lathe) |
| G33 | Thread Cutting (Mill) |
| G40 | Cancel diameter offset (Mill) Cancel tool nose offset (Lathe) |
| G41 | Cutter compensation left (Mill) Tool nose radius compensation left (Lathe) |
| G42 | Cutter compensation right (Mill) Tool nose radius compensation right (Lathe) |
| G43 | Tool length compensation (Mill) |
| G44 | Tool length compensation (Mill) -Sometimes G49- |
| G50 | Set coordinate system and max RPM (Lathe) |
| G52 | Local coordinate system setting |
| G53 | Machine coordinate system setting |
| G54-59 | Workpiece coordinate system setting #1 - #6 |
| G61 | Exact stop check |
| G65 | Custom macro call |
| G70 | Finish cycle (Lathe) |
| G71 | Rough turning cycle (Lathe) |
| G72 | Rough facing cycle (Lathe) |
| G73 | Irregular rough turning cycle (Lathe) Chip break drilling cycle (Peck)(Mill) |
| G74 | Face grooving or chip break drilling (Lathe) Left hand tapping (Mill) |
| G75 | OD groove pecking (Lathe) |
| G76 | Fine boring cycle (Mill) Threading cycle (Lathe) |
| G80 | Cancel cycles |
| G81 | Drill cycle |
| G82 | Drill cycle with dwell (Mill) |
| G83 | Peck drilling cycle (Mill) |
| G84 | Tapping cycle |
| G85 | Bore in, Bore out |
| G86 | Bore in, rapid out |
| G87 | Back boring cycle |
| G90 | Absolute programming |
| G91 | Incremental programming |
| G92 | Reposition origin point (Mill) Thread cycle cutting (Lathe) |
| G94 | Per minute feed (Mill) |
| G95 | Per revolution feed (Mill) |
| G96 | Constant surface speed control (Lathe) |
| G97 | Constant surface speed cancel (Lathe) |
| G98 | Per minute feed (Lathe) |
| G99 | Per revolution feed (Lathe) |
Quer criar seus próprios Flashcards gratuitos com GoConqr? Saiba mais.