|
Criado por Vincent Bergeron
aproximadamente 9 anos atrás
|
|
Name five operations that can be performed on a contour bandsaw.
Describe how to make to make the blade track properly.
Why must the upper saw guide be close to the top of the work?
What factors should be considered when selecting a blade for a contour cut?
How should the work be fed into a revolving saw?
How can the following bandsawing problems be corrected?
-Blade wander
How can the following bandsawing problems be corrected?
-Poor finish
How is the length of a blade calculated when the upper carrier wheel is extended the full distance?
Make a sketch to show how the ends of the bandsaw are positioned for grinding prior to welding.
To obtain the correct tooth spacing, how many teeth should be ground off each end of a 10 pitch blade? A 14-pitch blade?
What are characteristics of a good weld on a bandsaw blade?
List the main steps required to remove an internal section from a piece of work:
Describe the principle of friction sawing.
Why is friction sawing particularly suited to cutting stainless steel?
How does high-speed sawing differ from friction sawing?
List the main steps required to set up the machine for band filing?
What is the recommended filing speed?
How can the band file be kept clean?
Name five materials that can be cut satisfactorily with knife-edge bands.
Name two types of spiral-edge bands and state two uses for each.
Describe a line-grinding band and state its purpose.
Name five materials that may be cut with a diamond-edge band
Describe the principle of electro-band machining
Describe and state the purpose of:
-work-holding jaw
Describe and state the purpose of:
-disk-cutting attachment
Describe and state the purpose of:
-cutoff and mitering attachment