Open floor plan sample .dwg
Active the marketing named view
Insert the copy machine block at mid point of the Wall (1) whith a rotation of 270 derees
Assign it to the FURNITURE layer.
Edit the block definition to change the length of copy machine rack to 0.25 as shown in the exhibit

What is the distance for the lower left corner (2) of the copy machine to the midpoint of Wall (1)?
#.##

Open grips. dwg
Using grip, strech the right edge of the table to align with line 1
What is the cell width of one of the columns

Open Exterior Elevetions.dwg
Activate the south elevation named view.
Create a new hatch pattern in área 1 with the following properties and options:
Boundary method = Pick Points
Hatch pattern = BRSTONE
Hatch angle =0
Hatch scale =1
Layer = WALLS
Island detection = outer island detection

What is the área of the new hatch pattrern thet you created?

Open T-02xyz.dwg
Create new Mtext using the following parameters:

Use the exiting rectangle to select the first (1 ) and oppsite (2) corners.
Verify the text style is set to SANSERIF
Set the text height to 0.25
Change the justification top center
For the text, enter ALL EXISTIN DIMENSION TO BE VERIFIED
On the properties Palette, wath is the position x value of text?

Open VW252-03-1200.dwg
Zoom to the lower left hexagon
Modify the ISO Style 1 dimensions style so that presicion for the primary units is to three decimal places
Place the dimensión, as show in the exhibit, using the ISO Style 1 dimensión style
What is the dimensión value (1)?

Open Isometric dwg.

Create an Isometric view based off of exsting views
What is the distance from 1 to 2?

Openvw252-03-1200.DWG.
Active the add chanfer fillets named view.
Add two chanfer at corners 1 and 2 with all distances set at 1.75 units
Add a fillet at corner 3 whith the radius set at 1.75 units

What is the distance from the midpoint of chanfer 1 to the midpoint of fillet 3

Open Floor Plan Sample dwg.
Activate the copy room named view
Whith orther turned on, move the computer 2.5 units to the right and 1.5 units down

What is the distance of corner 1 to corner 2?

Open the drawing file Floor Plan Sample.dwg

Copy the ISO A1 Layout and rename the leyout to Plot Restore
Set the Following Page setup parameters.
Plot style: acad .ctb
Printer/plotter DWG to PDF. Pc3
Paper size: ISO expand A1 (841.00 x 594.00 mm)
Plot área: layout
Ploter scale: 1:1
Drawing Orientation: Landscape
Delete the existing viewport
Create a new viewport from one corner of the titleblock to the other.
In the viewport, actívate the Plot Restore named view

What number appears on the screen?