Brian Gamble
Quiz por , criado more than 1 year ago

CCNA ICND2 (Chapter 10) Quiz sobre ICND2 Ch 10 quiz, criado por Brian Gamble em 03-02-2016.

4
0
0
Brian Gamble
Criado por Brian Gamble mais de 8 anos atrás
Fechar

ICND2 Ch 10 quiz

ICND2 Ch 10 quiz

Questão 1 de 8

1

A classful network in which packets sent between at least one pair of subnets must pass through subnets of a different classful network.

Selecione uma das seguintes:

  • Contiguous

  • Discontiguous

Explicação

Questão 2 de 8

1

A classful network in which packets sent between every pair of subnets can pass only through subnets of that same classful network, without having to pass through subnets of any other classful network.

Selecione uma das seguintes:

  • Contiguous

  • Discontiguous

Explicação

Questão 3 de 8

1

What is Step 2 for EIGRP configuration?

Selecione uma das seguintes:

  • Impact metric calculations by tuning bandwidth and delay using the bandwidth value and delay value interface subcommand.

  • Set the EIGRP router ID (RID) explicitly with the eigrp router-id value router subcommand

  • Enter configuration mode and define the EIGRP autonomous system number (ASN) by using the router eigrp as-number global command.

  • Configure one or more network ip-address [wildcard-mask] router subcommands. This enables the EIGRP on any matched interface and causes EIGRP to advertise the connected subnet.

Explicação

Questão 4 de 8

1

Routes that are neither successor nor FS can never be added to the IP routing table regardless of the varianc e setting, because doing so may cause packets to loop.

Selecione uma das opções:

  • VERDADEIRO
  • FALSO

Explicação

Questão 5 de 8

1

R2 has two routes to network 10.0.0.0/8: one pointing left toward R1 and one pointing right toward R3. R2 simply uses its usual load-balancing logic, because as far as R2 can tell the two routes are simply equal-cost routes to the same destination: the entire network 10.0.0.0. Sometimes R2 happens to forward a packet toward the correct destination, and sometimes not. This problem has two solutions; what are they?

Selecione uma ou mais das seguintes:

  • Create IP addressing plans that do not create discontiguous classful networks

  • Use autosummary by using EIGRP defaults

  • Create IP addressing plans that create discontiguous classful
    networks

  • Do not use autosummary by using EIGRP defaults

Explicação

Questão 6 de 8

1

The only difference compared to OSPF is that the EIGRP RID is configured with the __________________ router subcommand, whereas OSPF uses the router-id value subcommand.

Selecione uma das seguintes:

  • Router eigrp

  • Eigrp router-id value

  • Show ip route eigrp

  • none of these

Explicação

Questão 7 de 8

1

What is the report distance (RD)?

Selecione uma das seguintes:

  • What is the report distance (RD)?

  • The metric of the best route to reach a subnet

  • The result of the calculation of the EIGRP metric for a route

  • The metric calculated from the perspective of the next-hop router

Explicação

Questão 8 de 8

1

In real networks, most people prefer to use autosummary today

Selecione uma das opções:

  • VERDADEIRO
  • FALSO

Explicação

Anterior
Próximo