Este Quiz é cronometrado.
Você tem 20 minutos para completar as 14 questões deste quiz..
When should the cell unit be installed in the panel?
After the installer calls in with his Serial Number information
Before the panel is powered on.
When the power is powered on
Both A and C
Can you use the speaker phone on a GSM account?
In order to send Signals through Alarm.com what steps need to be taken first?
Delete phone number in Phone 1.
You don’t, the GSM is automatically verified and it turns itself on.
Send a Cell test
Under System Type, turn off Phone line and turn on GSM.
Where do you program the Duress code?
In zone 92
There is no Duress on the GC3
User programming user codes
Fluent does not use a Duress code so it doesn’t matter
Why would a sensor work only once and then show a fault?
Low Battery
Bad RF range
Wrong Loop number
Wrong Serial Number
What is acceptable GSM signal strength?
2-6
6-31
0-1
None of the above
What is unacceptable GSM signal strength?
2 stars
2g
What is radio modem network failure?
GSM fault
Translator Error
Wi-Fi failure
Improper Line Seizure
How many screws are needed to attach the GSM to the back of the panel board?
2
3
4
No screws are required
What could happen if the GSM is not installed properly on the back of the panel board?
Lack of proper GSM signaling
Loose connections
Possible return trip for service
All of the above
At what temp does the Ecolink freeze sensor need to be and how long to send the freeze signal?
42*F or 6*C for up to 10 minutes
Can be customized by customer
When it is really cold
32*F or 0*C for up to 5 minutes
2GIG Motion Detectors also have freeze sensors in them?
2GIG Smoke Detectors also have freeze sensors in them?
You can have 2 doors with different Delayed Entry times?
