How many different outputs can an A/M 32A-60 provide?
2
3
4
5
Which item is the only auxiliary power unit (APU) to provide both electrical and pneumatic power?
A/M 32A-60
A/M 32A-86
A/M 32A-95
MC-2A
Where is the A/M 32A-60 pneumatic duct hose stored?
On the unit's roof housing
In the rear storage compartment
In the front storage compartment
In the chassis storage compartment
Identify the output of the A/M 32A-95
28 VDC
Bleed air
120 VAC, single-phase, 400 Hz
120/208 VAC, three-phase, 400 hz
Due to the expansion properties of fuel, an unmodified A/M 32A-95 fuel tank should not be filled more than approximately how full?
1/3
1/2
5/8
3/4
Which electrical output is supplied by the A/M 32A-86 generator set?
110/120 VAC or 208/230 VAC
115/200 VAC or 230/400 VAC
120/208 VAC
How many instruments/control panels must the operator make use of during operation of the A/M 32A-86 generator set?
1
Which panel of the A/M 32A-86 generator set has the circuit breaker to shut off current flow in case of an overload?
Generator control
Engine control
External AC
External DC
Which auxiliary power unit serves as an external power source for the MQ-1 and MQ-9 aircraft?
Starter cart assembly (SCA)
Where is the control panel of the starter cart assembly (SCA) located?
Underneath a cover located at the top of the unit
On the engine monitoring panel
On the power outlet located on the right side of the generator set
On the starter cart assembly electronics tray
An operator is not required at or in the immediate vicinity of an in-use auxiliary power unit (APU) when they are practicing loading
High explosive munitions
Live nuclear weapons
Live chemical weapons
Inert training munitions
Fighter aircraft may be exempted from the 50 foot distance placement requirements of an auxiliary power unit (APU) during
Combat operations only
Simulated combat operations only
Combat or simulated combat operations
Combat, simulated combat, or adverse weather conditions
Which area must you void when operating units powered by turbine engines?
Engine air intake
Engine air exhaust
Engine plane of rotation
Power unit bleed air service hose
Which air compressor may be used to per ate small pneumatic tools?
MC-1A
MD-3
How much air pressure is produced by the MC-2A air compressor?
5 cfm at 200 psi
15 cfm at 200 psi
5 cfm at 3200 psi
15 cfm at 3200 psi
Before you connect or disconnect a high-pressure service hose, you must make sure the system is not
Pressurized with more than 100 psi
Pressurized with more than 15 psi
Pressurized fully
Pressurized
Which power output of a portable floodlight set is used for powering common electrically powered hand tools?
115-120 VAC
220-240 VAC
225-300 VAC
The FL-1D can serve as a ground power source for MQ-1 and MQ-9 aircraft when used in conjunction with a/an
MC-2A air compressor
A/M 32A-60 generator set
A/M 32C-10A air conditioner
DCs40-75 "Sorensen" power supply unit
When can you use the floodlight receptacles for external power to operate accessories
When 115-120 VAC is required
When 110-115 VAC is required
When 235-300 VAC is required
Never, these receptacles cannot be used to operate accessories
How are flood lights positioned when working around aircraft?
Downwind from the A/C
At the end of their power cord
50 feet away from the A/C nearest point
As far away as possible from the A/C, while still providing adequate lighting
In which position must the FL-1D's floodlight platform be placed during towing?
Any position
Lowered halfway
Lowered completely
Lowered just enough to clear overhead obstacles
Which storage compartment is the A/M 32C-10 duct hoses stored?
Unit's roof housing
Rear
Front
Chassis
Which A/M 32C-10 control panel will you use when operating the system?
High pressure air controls
Conditioned air controls
Generator control panel
Direct current (DC) power panel
How far from the supported aircraft should the A/M 32C-10 air conditioner be positioned for optimum unit operating efficiency and safety?
8 to 10 feet
10 to 12 feet
15 to 30 feet
50 feet minimum
Which per pound per square inch (psi) is the maximum amount of bleed-air pressure that may be applied to the -10 air conditioner?
15 psi
25 psi
35 psi
45 psi
How many operators are required to be present during the operation of the -10 air conditioner?
Which additional piece of aerospace ground equipment (AGE) is required during the operation of the polyalphaolefin (PAO)/air cooling cart?
A/M 32A-86 generator set
A/M 32A-95 generator set
None, it is a self-contained system
How many fluid temperature modes are available on the polyalphaolefin (PAO)/air cooling cart?
How does the operator initiate the delivery of polyalphaolefin fluid once it has reached proper operating temperature?
By closing the aft restrictor valve
By opening the aft restrictor valve
By opening the aft restrictor manifold
The operator takes no action, the polyalphaolefin (PAO)/air cooling cart begins fluid delivery automatically
Which action must be ensured before making or breaking a connection between the polyalphaolefin (PAO)/air cooling cart and the aircraft?
Cart power is off
System is depressurized
Servicing lines are bled
Servicing lines are free of kinks
The cool-air hatch on the MJ-2A hydraulic test stand is located on the unit, by which location on the unit?
Side
Top
Which personnel protective equipment (PPE) must be worn when you operate the MJ-2A?
Goggles
Ear protectors
Gloves
Coveralls
Identify the primary reason for making sure aircraft fittings are clean before attaching hydraulic servicing hoses?
Dirty fittings will cause damage to the threads of the connectors on the test stand
Dirty fittings can cause an incomplete seal with the hoses resulting in leaks at the attach points
Dirty fittings can introduce contaminants to the hydraulic system causing damage to valves and lines
Dirt can scour protective coatings off of the fittings that will allow then to corrode when bare metal is subjected to the environment
Which aircraft(s) require aircraft armament system personnel to use the self-generating nitrogen servicing cart (SGNSC)?
F-15, F-16, and F-22
B-1, B-2, and B-52
F-15 and F-15E
F-22 only
When using the self-generating nitrogen servicing cart (SGNSC) why is it important that waste gasses are not allowed to accumulate in an enclosed space?
Dangerous levels of carbon monoxide can build up displacing space
Dangerous levels of carbon dioxide can build up displacing oxygen
Excess nitrogen can pose a fire or explosion hazard
Excess oxygen can pose a fire or explosion hazard
Why is it important to prevent venting the self-generating nitrogen servicing cart (SGNSC) storage tanks in an enclosed space without sufficient ventilation?
Excess nitrogen can pose a fire/explosion hazard
Venting of high pressure gas is extremely loud and could damage hearing
A dangerous overpressure situation could occur causing harm to personnel and damage to structures
Large volumes of nitrogen can displace the oxygen in the air, making it possible for a person to suffocate without warning
Which precaution must be taken prior to attempting to loosen fittings, or removing tubes or hoses when using the self-generating nitrogen servicing cart (SGNSC)?
Ensure cart power is off
Ensure the entire system is depressurized
You must vent the pressure from that part of the system through the appropriate valve
Ensure the carts high pressure storage tanks main shutoff valves are in the "NO-FLOW" position
the maximum static load the B-1maintenance stand can sustain is
300 pounds
400 pounds
500 pounds
600 pounds
Identify the platform height range of the B-4 maintenance stand?
3 to 7 feet
4 to 8 feet
3 to 10 feet
4 to 12 feet
The hand pump for raising the B-4 maintenance stand is located on the
Platform near the ladder
Remote control unit (RCU)
Base of the stand near the aft castors
Base of the stand near the forward castors
Which maintenance stand is described as a scissors-type, with a variable height platform, and mounted on a long-legged caster-equipment base?
B-1
B-4
B-5
C-1
Identify the platform height range of the B-5 maintenance stand
1 to 7 feet
1 to 10 feet
7 to 12 feet
7 to 15 feet
Which stand can be used independently, or can be installed as an extension on the B-1maintenance stand?
B-2
The lifting capacity of the davit on the split deck is
200 - 500 pounds
250 - 500 pounds
300 - 500 pounds
350 - 500 pounds
If the split-deck maintenance platform's tape switches detect an obstruction during an operation, what will the switches stop on the unit?
Forward drive capacity only
Platform extension capability
Platform extension and lowering capabilities only
Forward drive, platform extension and lowering capabilities
During an operator's pre-use inspection of aerospace ground equipment (AGE), what is required by the operator to ensure proper unit operation?
Check the AFTO 781K
Check the AGE personnel as the status of the unit
Cycle the unit through the capabilities that you will use
Cycle the unit completely through its range of capabilities
Which AFTO form is used to annotate any defects you may find on your aerospace ground equipment (AGE)?
AFTO Forms 244 and 245
AFTO Form 349
AFTO Form 350
AFTO Form 781A
