PDD Part A

Descrição

ARCH PDD Quiz sobre PDD Part A, criado por M. A. em 05-01-2022.
M. A.
Quiz por M. A., atualizado more than 1 year ago
M. A.
Criado por M. A. aproximadamente 3 anos atrás
6
0

Resumo de Recurso

Questão 1

Questão
Consider a medium-sized commercial building that has a single fan room located on the ground floor, adjacent to the NW façade of the building. If the exhaust air and the fresh air louvers, aligned horizontally O.C. are respectively 12 ft and 15 ft wide, what is the minimum width (dimension parallel to the façade) of the fan room?
Responda
  • 27'
  • 32'
  • 37'
  • 47'

Questão 2

Questão
Which type(s) of PV cells is (are) the most efficient?
Responda
  • Thin Film Cells
  • Monocrystalline Silicon Cell
  • Thin Film Cells and Polycrystalline Silicon Cell
  • Monocrystalline Silicon Cell and Thin Film Cells
  • Polycrystalline Silicon Cell

Questão 3

Questão
Which of the following are required by the IBC to be submitted as part of the submittal documents of a given project? Select 4.
Responda
  • Fire Protection System Shop Drawings
  • Mechanical system design criteria
  • Floor Live Load
  • Exterior Wall Envelope
  • Insulation materials and their R-values
  • Site Plan

Questão 4

Questão
Which of the following sentences are correct? Choose 3.
Responda
  • Type O and M mortar mixes are more commonly found in exterior applications
  • Type M and N mortar mixes are widely used in foundations
  • Type K mortar mix has the lowest compressive strength
  • Type O mortar mix is commonly used for interior non load-bearing applications
  • Type O mortar mix is a good choice for repairing existing structures
  • Type S mortar mix is the most commonly used mortar mix

Questão 5

Questão
If a drawing set is organized per the Uniform Drawing System by the National CAD Standard, what would you most likely find in the sheet A-403?
Responda
  • Elevations
  • Large-scale bathroom sections
  • Details
  • Sections

Questão 6

Questão
_________ soften when heat is applied and re harden when cooled, so the pipe can be extruded or molded into shapes.
Responda
  • Thermoset plastics
  • Thermoplastics
  • Elasticthermo
  • Soft Temper

Questão 7

Questão
In a large commercial building using an all-air heating and cooling system, where should the air handling unit(s) be ideally located?
Responda
  • Basement
  • Near vertical distribution shafts
  • At any floor as long as adjacent to an exterior wall
  • Top floor

Questão 8

Questão
Which of the following construction materials has the highest modulus of elasticity?
Responda
  • Brass
  • Aluminum
  • Concrete, High Strength
  • Douglas fir wood

Questão 9

Questão
An egress stairway serving an occupant load of more than 49, must have a minimum width of [blank_start]____[blank_end] inches. Fill in the blank numerically. Ex: 52
Responda
  • 44

Questão 10

Questão
If the specifications of a given project are organized per the 2018 CSI MasterFormat, what would you most likely find in Division 07?
Responda
  • Roller Window Shades
  • Automatic Window Equipment
  • Exterior Architectural Woodwork
  • Built-Up Asphalt Roofing

Questão 11

Questão
Which of the following specification types is usually more difficult to write?
Responda
  • Performance
  • Descriptive
  • Proprietary
  • Reference Standard

Questão 12

Questão
Consider a beam that spans 28′, supported at each extremity by supports R1 and R2. There are two concentrated loads (11,300 lbs and 8,100 lbs) on the beam and they are 5’ apart. The heavier load is centered on the beam and the lighter load is closest to support R2. Calculate the reactions of both supports, disregarding the weight of the beam itself.
Responda
  • R1 = 8,254 lbs / R2 = 11,146 lbs
  • R1 = 11,146 lbs / R2 = 19,400 lbs
  • R1 = 11,146 lbs / R2 = 8,254 lbs
  • R2 = 11,146 lbs / R1 = 19,400 lbs

Questão 13

Questão
________ water distribution systems are also commonly referred to as ___________ systems.
Responda
  • Upfeed / Gravity
  • Downfeed / Indirect
  • Upfeed / Indirect
  • Downfeed / Direct

Questão 14

Questão
If the specifications of a given project are structured per the SectionFormat system, where are the Unit Prices of a given product located within its section?
Responda
  • Part 0
  • Part 1
  • Part 2
  • Part 3

Questão 15

Questão
Which copper grade(s) is(are) more commonly used for potable water service?
Responda
  • Types K and L
  • Types K, L and M
  • Type ACR
  • Type DWV

Questão 16

Questão
What is true regarding the image?
Responda
  • Metal flashing should not stand out as much from the face of the brick
  • Membrane should be visible on the exterior of the wall, between metal flashing and mortar
  • The image shows a troweled mortar joint
  • None of the above

Questão 17

Questão
What is the hand of the door shown in the image?
Responda
  • RH
  • LHR
  • LH
  • RHR

Questão 18

Questão
The national average cost for a monolithic concrete slab foundation is $4.32/sf. If the cost index for Milwaukee is 93.27, what is the total construction cost of the same foundation, assuming the same total square footage of 132,000 sf?
Responda
  • $570,240
  • $531,863
  • $4.63
  • $611,386

Questão 19

Questão
If a drawing set is organized per the Uniform Drawing System, what would be the correct order of the following disciplines?
Responda
  • Landscape, Structure, Architecture, Plumbing, Mechanical, Hazardous Materials
  • Hazardous Materials, Structure, Architecture, Landscape, Mechanical, Plumbing
  • Structure, Architecture, Landscape, Plumbing, Mechanical, Hazardous Materials
  • Hazardous Materials, Landscape, Structure, Architecture, Plumbing, Mechanical

Questão 20

Questão
What type of water is more commonly used for mixing concrete?
Responda
  • Greywater
  • Groundwater
  • Potable water
  • Distilled water

Semelhante

PDD Quiz XII
a a
PDD Quiz I
a a
Temas de Redação ENEM 2014
Alessandra S.
Genética Molecular: Ácidos Nucleicos
Renata Cavazzana
LEI 8080
Camila Costa
Mapas Mentais em Sala de Aula
GoConqr suporte .
FCE Opposites Practice
titaleoni
Plano de estudos ENEM - Parte 1 *Humanas
Alice Sousa
REVISÃO DO ENS FUNDAMENTAL
Paulo César R. Silva
Planejamento e Controle da Produção
Luciana Amaral Pereira Freire
Trabalho de Português
Williana Karoline Vieira Fontenele