for everyone quiz

Descrição

power engineering 3b2 Quiz sobre for everyone quiz, criado por TRAVIS CANNING em 28-02-2016.
TRAVIS CANNING
Quiz por TRAVIS CANNING, atualizado more than 1 year ago
TRAVIS CANNING
Criado por TRAVIS CANNING quase 9 anos atrás
4
1

Resumo de Recurso

Questão 1

Questão
In an ammonia absorption system, the strong liquor is composed of which of the following?
Responda
  • Ammonia and salt
  • Ammonia and brine
  • Water and ammonia
  • None of the above
  • All of the above

Questão 2

Questão
At a pressure of around 240 kpa, ammonia will boil off at a temperature of about___, in the evaporator by absorbing heat from the medium to be cooled?
Responda
  • -89 degrees
  • -65 degrees
  • -15 degrees
  • 10 degrees
  • None of the above

Questão 3

Questão
An intercooler used in a compression refrigeration system serves to do which of the following?
Responda
  • Reduce the vapor temperature
  • Increase vapor density
  • Permits a decrease in the power consumption of the high pressure compressor
  • All of the above
  • None of the above

Questão 4

Questão
Which of the following is incorporated between the discharge and suction of two separate single stage compressors in order to remove some of the heat added in the low pressure stage?
Responda
  • Intercooler
  • Aftercooler
  • Evaporator
  • Condenser
  • None of the above

Questão 5

Questão
In order to handle large volumes of vapor coming from the evaporator, multi- stage plants may employ which of the following for the first of low pressure stage?
Responda
  • Vaporization Compressor
  • Booster compressor
  • Variable speed compressor
  • All of the above
  • None of the above

Questão 6

Questão
Which of the following maintains a constant level of liquid refrigerant in the evaporator?
Responda
  • Expansion valve
  • Liquid receiver
  • Evaporator float valve
  • None of the above
  • All of the above

Questão 7

Questão
The different types of refrigeration plants are which of the following?
Responda
  • Constant Expansion system
  • Direct system
  • Indirect system
  • B and C
  • All of the above

Questão 8

Questão
In the duplex compressor system, the condenser for the first stage is the evaporator for the second stage?
Responda
  • True
  • False

Questão 9

Questão
Which of the following are different types of construction for an evaporator?
Responda
  • Bare tube
  • Finned Tube
  • Plate surface
  • 1 and 2
  • All of the above

Questão 10

Questão
Which of the following are major components of the high pressure ammonia refrigeration system?
Responda
  • Compressor
  • Condenser
  • Evaporator
  • Liquid Receiver
  • All of the above

Questão 11

Questão
Some of the most common refrigerants used today are which of the following?
Responda
  • Refrigerant R- 12
  • Refrigerant R- 22
  • Refrigerant R- 134a
  • Ammonia
  • All of the above

Questão 12

Questão
Which of the following properties should fluids, used as a refrigerant, possess?
Responda
  • Non flammable
  • Non corrosive
  • Non toxic
  • Operate under low pressure (low boiling point)
  • All of the above

Questão 13

Questão
When starting up a compressor and a leak has been found, which of the following steps would be the corrective action?
Responda
  • Shut down the compressor until the leak is repaired
  • Continue with the start up and ignore the leak
  • If possible, bypass the line which is leaking
  • All of the above
  • None of the above

Questão 14

Questão
What would be the final step in the start up of a compressor?
Responda
  • Check the gearbox oil level
  • Slowly load up the compressor
  • Close the breaker for the compressor motor
  • Check for leaks and unusual noises
  • None of the above

Questão 15

Questão
Which of the following steps comes first when starting up a compressor that was taken down for maintenance?
Responda
  • Start the compressor
  • Check oil levels
  • Ensure no one is working on the compressor
  • Turn on the cooling water for the compressor cylinders
  • Open the suction and discharge valves

Questão 16

Questão
Which of the following should never be placed in the line between compressor and receiver, unless a safety valve is used?
Responda
  • Drain valve
  • Pressure regulator
  • Orifice plate
  • Shut off valve
  • None of the above

Questão 17

Questão
Air receivers serve to perform which of the following functions?
Responda
  • Act as a reservoir in the compressed air system
  • Acts to dampen pulsations in the discharge pressure
  • Allows moisture, dust, and oil to settle out from the air
  • All of the above
  • None of the above

Questão 18

Questão
The standard desiccant used in an air dryer system is which of the following?
Responda
  • Activated alumina
  • Silica gel
  • Potassium oxide
  • 1 and 2
  • None of the above

Questão 19

Questão
Which of the following are components of an air dryer system?
Responda
  • Prefilters
  • Dryer tanks or towers
  • Afterfilters
  • All of the above
  • None of the above

Questão 20

Questão
Which of the following functions does the dry air receiver serve to do?
Responda
  • Stabilizes the system pressure as it acts as a demand reservoir
  • Helps avoid overloading the air purification system with surges in air demand
  • Dampens out the dew point and temperature spikes
  • All of the above
  • None of the above

Questão 21

Questão
Which of the following functions does the wet air receiver serve to do?
Responda
  • Stabilize flow though the air driers on system load changes
  • Additional moisture separation
  • Provides storage capacity to prevent rapid compressor cycling
  • All of the above
  • none of the above

Questão 22

Questão
What is the main purpose of an intercooler?
Responda
  • To remove any entrained moisture
  • To reduce the volume of the air
  • To maintain the outlet temperature
  • All of the above
  • None of the above

Questão 23

Questão
Which of the following are some of the reasons for using intercoolers and aftercoolers to cool down the air?
Responda
  • To condense out water vapor and drain from the system
  • To remove all oil vapors that will have detrimental effects on the system
  • Decrease the amount of power to compress the air
  • To make cylinder lubrication more effective
  • All of the above

Questão 24

Questão
Some common methods used to reduce “surging” would be?
Responda
  • Throttling the inlet valve
  • Reducing the compressor speed
  • Venting of the discharge line to atmosphere, or to the suction line
  • All of the above

Semelhante

15 Dicas para Passar nos Exames
Alessandra S.
O QUE ESTUDAR PARA OAB
Maria José
Direito Administrativo - Visão Geral
tiago meira de almeida
Uso do HÍFEN
Viviana Veloso
Plano de Estudo Vestibular- Semana 1
Alessandra S.
DIREITOS E DEVERES INDIVIDUAIS E COLETIVOS #6
Eduardo .
Principais temas para estudar Português
Marina Faria
História do Mundo
Raíza Da Cunha
DESENVOLVIMENTO DE COMPETÊNCIAS
santiagoamaral
5 Ferramentas de Estudo para Melhorar sua Aprendizagem -Vestibular e Enem
GoConqr suporte .
ADMINISTRAÇÃO PÚBLICA
Mateus de Souza