6248865
Descrição
Quiz por Miguel Ángel Martínez Lara, atualizado more than 1 year ago
|
Criado por Miguel Ángel Martínez Lara
aproximadamente 8 anos atrás
|
|
Questão 1
Questão
You can use these to combine two wires, they are often used in electrical work.
Responda
-
Long Nose Pliers
-
Combination Pliers
Questão 2
Questão
It is the action of join two materials by deforming one of them through the use of a force.
Responda
-
To crimp
-
To cut
-
To screw
Questão 3
Responda
- True
- False
Questão 4
Questão
Long Nose Pliers
Responda
Questão 5
Questão
I use this tool to cut the end of the wires before crimping them into an RJ-45 connector.
Responda
Questão 6
Questão
These tools are used to carefully put or extract little electronic components.
Responda
- True
- False
Questão 7
Questão
This tool is used to tighten or loosen flathead screws.
Responda
-
Slotted screws
-
Flat screwdriver
-
Hex screwdriver
Questão 8
Questão
Slotted screw
Responda
Questão 9
Questão
This tool is used to insulate a wire.
Responda
- True
- False
Questão 10
Questão
This tool is used to crimp a kind of connector with a wire.
Responda
Questão 11
Questão
These are cutting tools. (Select three)
Responda
Questão 12
Questão
This is used to avoid an electrical discharge when working on elecronic components.
Responda
- True
- False
Questão 13
Questão
Tools used to tighten and loosen nuts and bolts. (Select two)
Responda
Questão 14
Responda
- True
- False
Questão 15
Questão
The action of dividing something into smaller pieces.
Responda
-
To crimp
-
To cut
-
To tight
Questão 16
Questão
What is the first step to solder?
Responda
-
Heat the soldering iron.
-
Make sure the tip is clean.
-
Put the components together.
Questão 17
Questão
After soldering, the soldering iron should be held for another second to melt the solder before retiring it.
Responda
- True
- False
Questão 18
Questão
If you have a mistake you can remove it by using a [blank_start]desoldering tool[blank_end].
Responda
-
desoldering tool
-
flux
-
soldering tip
-
component
Questão 19
Questão
It is important to heat the soldering iron so the solder can be [blank_start]melted[blank_end] on the two components which are going to be bonded.
Responda
-
melted
-
melt
-
melting
-
didn't melt
Quer criar seus próprios Quizzes gratuitos com a GoConqr? Saiba mais.