Electronics Technician - Ongoing (diagrams/schematics I need to study)

086096 15 (binary/octet-stream)

Electron Flow Theory

Rubrica: : woah

Electron flow theory is shown here. Remember that a direct current is the continual flow of electrons in the same direction. A common source of direct current is a battery. In the circuit illustrated here, electrons move from the negative (-) battery terminal, through the lightbulb, and back to the positive (+) terminal.

Anatomy of a Dry Cell Battery

A dry cell battery is composed of a zinc shell filled with a chemical paste called electrolyte. A carbon rod is then inserted into the paste. As a result, a chemical reaction occurs within the battery, and a  lack of electrons develops at the carbon rod. The rod therefore becomes the positive terminal and is labeled with a positive (+) sign. At the same time in the battery, a surplus of electrons develops in the zinc shell. The shell then becomes the negative terminal and is labeled with a negative (-) sign.

Battery+Construction (binary/octet-stream)

#2 (binary/octet-stream)

Rubrica: : Would you look at that! A water system looks just like an electric circuit.

Comparing Electricity with Water

Potentiometer (binary/octet-stream)

Rubrica: : The major parts of a potentiometer include a resistive strip, a sliding contact, and a rotating shaft.

Anatomy of a Potentiometer

Schematic+Symbols (binary/octet-stream)

Rubrica: : Here are some of the standard symbols used to indicate electrical components in schematic diagrams.

Basic Component's Schematic Symbols

Relay+Circuit+Ex. (binary/octet-stream)

Relay Ladder Logic Diagram

Rubrica: : In this relay circuit, the contacts of the relay will change when the coil of the relay is energized.

This type of diagram is called a relay ladder logic diagram. This is because the diagram looks like a ladder with rails and rungs.  Note that the two vertical "rails" are connected to the power source. The horizontal "rungs" contain the switches, coils, and loads for the circuit. The rungs are actually simple series circuits that are connected between the power rails and controlled by one relay contact on each rail.

Example of a Short Circuit

Short+Circuit (binary/octet-stream)

In this illustration, current flows through the first resistor (R1), and then short circuits, bypassing the second and third resistors (R2 and R3).  This greatly increases the current in the circuit. 

Rubrica: : intense

086096 25 (binary/octet-stream)

086096 21 (binary/octet-stream)

Rubrica: : High-power Rheostat Back View

Rubrica: : Main External Parts of a Potentiometer

Potentiometer & Rheostat Anatomy