13482824
Description
Quiz by james crowley, updated more than 1 year ago
|
Created by james crowley
almost 7 years ago
|
|
Question 1
Question
Which one of the following items will require special attention when using a steam
stripper in a domestic environment?
Answer
-
a Television.
-
b Desk.
-
c Kettle.
-
d Radiator.
Question 2
Question
Plastic sheeting is sometimes placed under cotton dust sheets when protecting furniture.
Why is this?
Answer
-
a To protect the plastic sheeting.
-
b To prevent dust from transferring through.
-
c To prevent the sheets from slipping off.
-
d To save on the use of cotton sheets.
Question 3
Question
Due to its lightness, which one of the following is generally the best sheeting for
covering office equipment?
Answer
-
a Tarpaulin.
-
b Plastic sheet.
-
c Adhesive plastic.
-
d Cotton twill.
Question 4
Question
Which one of the following tapes would be the most suitable for masking a previously
painted surface?
Answer
-
a Low tack tape.
-
b Duct tape.
-
c Masking tape.
-
d Insulation tape.
Question 5
Question
Which one of the following identifies the best reason for carefully removing masking tape
after the painting has been completed?
Answer
-
a To save time cleaning up.
-
b To allow the paint to flow.
-
c To re-use the masking tape.
-
d To stop paint being lifted off.
Question 6
Question
Which one of the following is the most important reason for professionally cleaning dust
sheeting after use?
Answer
-
a To prevent cross-contamination.
-
b To ensure a professional image.
-
c To remove insects.
-
d To remove old paint.
Question 7
Question
Which of the following component parts of a brush is used to bind the setting to the
handle?
Answer
-
a Ferrule.
-
b Stock.
-
c Frame.
-
d Filling
Question 8
Question
A short pile Mohair roller is unsuitable for applying emulsion to an embossed surface
because the
Answer
-
a roller would over fill the surface
-
b mohair would come away
-
c roller would skim over the surface
-
d rolling would take too long.
Question 9
Question
A water-borne gloss is being applied to a window cill. Why might a synthetic filament
brush be used specifically for this task?
Answer
-
a The filament is easier to clean after use.
-
b The brush marks produce a good texture.
-
c The filament brush is cheaper.
-
d The brush marks are less visible.
Question 10
Question
Which one of the following defects may occur if a tin of solvent-borne undercoat paint is
not prepared before use?
Answer
-
a Delayed drying time.
-
b Increased odour.
-
c Blooming.
-
d Cissing.
Question 11
Question
Which one of the following surface coatings allows timber to ‘breathe’?
Answer
-
a Gloss paint.
-
b Eggshell paint.
-
c Silk-emulsion paint.
-
d Micro-porous paint.
Question 12
Question
Which one of the following paint types would not be stirred prior to use?
Answer
-
a Gloss.
-
b Thixotropic.
-
c Silk-emulsion.
-
d Micro-porous.
Question 13
Question
What evaporates when an aluminium primer dries?
Answer
-
a Cellulose thinner.
-
b Methylated spirit.
-
c Distilled water.
-
d White spirit.
Question 14
Question
A common problem associated with gloss paint drying in hot and dry conditions is
Answer
-
a rapid drying
-
b loss of gloss
-
c cissing
-
d crazing
Question 15
Question
The first component of a panelled door to be painted is the
Answer
-
a stiles
-
b rails
-
c muntins
-
d mouldings.
Question 16
Question
If gloss is applied on top of an undercoat of the wrong colour, which defect is likely
to occur?
Answer
-
a Grinning.
-
b Flashing.
-
c Bleeding.
-
d Bleaching.
Question 17
Question
Careless application of solvent-borne gloss by roller can cause which of the following
defects?
Answer
-
a Blooming.
-
b Cissing.
-
c Crazing.
-
d Skid marks.
Question 18
Question
Strongly coloured painted surfaces exposed to direct sunlight over time may experience
Answer
-
a bleeding
-
b flaking
-
c fading
-
d cissing.
Question 19
Question
If a surface is described as ‘friable’, it would appear
Answer
-
a flaking/crumbling and dry
-
b wet/damp and mouldy
-
c soapy and white
-
d as dry powder crystals.
Question 20
Question
A synthetic filament brush has been used with water-borne gloss paint. Which one of the
following cleaning methods should be used?
Answer
-
a Remove excess paint, wash in sugar soap.
-
b Remove excess paint, wash in methylated spirit.
-
c Remove excess paint, wash in water.
-
d Remove excess paint, wash in solvent.
Question 21
Question
How should roller sleeves be stored after cleaning and drying?
Answer
-
a Laid flat in a dry place.
-
b Placed upright in a dry place.
-
c Suspended upright in water.
-
d Laid, submerged in water.
Question 22
Question
How should materials with low ‘flash points’ be stored?
Answer
-
a Away from other paints.
-
b At specific temperatures.
-
c Stored outside only.
-
d In direct sunlight.
Question 23
Question
An important reason for stock rotation is to
Answer
-
a prevent stock from degrading
-
b ensure that recent stock is used first
-
c get the best value from bargain prices
-
d minimise the theft of materials.
Question 24
Question
Why does paint sometimes ‘skin’ after use?
Answer
-
a Because the solvent evaporates and the surface drys.
-
b Because the oil has leaked from the bottom of the tin.
-
c Due to inappropriate stirring after use.
-
d Due to an incorrect storage temperature.
Question 25
Question
When the components of paint separate in the tin, this is known as
Answer
-
a crazing
-
b blooming
-
c cissing
-
d settling.
Want to create your own Quizzes for free with GoConqr? Learn more.