Question 1
Question
A vehicle that can receive ship and deliver a single shipment of radioactive material?
Question 2
Question
What five things do you need to make an X-ray?
Answer
-
High voltage source
-
Collimator
-
Filament-emits electrons
-
Target
-
Vacuum to travel in
-
Lead screens
-
Source of energy
Question 3
Question
a trainee and an instructor make a shot on a Weld. After exposure, the instructor retracts the source and completes a survey .While setting up for the next shot, the source, due to tube compression, moves from the shielded position. The instructor moves to the camera for his survey meter and notices the 'reading. He immediately leaves the tank and realizes the crank is half a turn off. What is the possible cause in the above situation??
Answer
-
Instructor failed to do a proper survey
-
lnstructor failed to read his pocket dosimeter
-
Instructor failed to secure the source
-
Instructor failed to fully retract source (Would •have had high readings during survey)
Question 4
Answer
-
Cancer
-
Radiation burn
-
Radiation sickness
-
none of the above
Question 5
Question
Name the numerical constant that describes the rate at which a radioactive material decays.
Answer
-
Dose equivalent constant
-
Exposure constant
-
Dose rate constant
-
Decay constant
Question 6
Question
What 4 things must be inspected annually on an X- ray machine?
Question 7
Question
Whose job is it to see if your X-ray machine is properly labeled?
Answer
-
State inspector
-
RSO
-
You
-
None of the above
Question 8
Question
What would the X-Ray machines control panel read?
Answer
-
When energized, this unit will produce Radiation
-
Do not operate without permission
-
Use by authorized personnel only
-
All of the above
Question 9
Question
If your dosimeter is damaged and is fully discharged, this will give you:
Question 10
Question
The unit of measure that measures irradiated material is?
Answer
-
rem
-
kVp
-
curies
-
absorbed dose
Question 11
Question
A site that is not listed on the registrant's license is considered?
Answer
-
A temporary job site
-
Non-Notified job site
-
Illegal job site
-
Unlisted job site
Question 12
Question
You are at a temporary job site with a safe line and signs posted. An unauthorized person walks into your Barricade. What do you do?
Answer
-
Raise his attention and tell him to leave the area
-
Try to get his attention, ask him to leave, and if he remains, retract the source and contact security (Or, retract the source immediately)
-
Stop him and tell him the dangers of radiation until he understands
-
Give him a survey meter for immediate....?
Question 13
Question
A vehicle transporting an X-ray machine:
Question 14
Question
The energy passing from the filament to the target in an X-Ray machine is called?
Answer
-
Passing tube
-
Carrier tube
-
Tube current
-
None of the above
Question 15
Question
Conforms to DEQ regulations, but not ran by DEQ?
Answer
-
Agreement states
-
Non-agreement states
-
Neither
Question 16
Question
Who regulates the X-Ray programs?
Question 17
Question
X-Rays are measured in?
Question 18
Question
Which requires the least amount of regulating?
Answer
-
X-Ray cabinet
-
Enclosed X-Ray cabinet
-
Certified X-Ray Cabinet
Question 19
Question
The energy from a CO 60 source is ____________ times greater than the energy from an Ir 192 source.
Answer
-
4
-
7
-
2
-
6
-
None of the above
Question 20
Question
Gamma rays measured in?
Answer
-
GmR's
-
MeV
-
Gmu
-
Both GmR's and MeV
Question 21
Question
What is the strongest available source?
Answer
-
Cs137
-
CO 60
-
lr192
-
None of the above
Question 22
Question
Where should a camera be stored in a truck?
Question 23
Question
When transporting an exposure device, what should it be transported in?
Question 24
Question
What is the best personnel monitoring device?
Answer
-
Film badge
-
TLD
-
Pocket dosimeter
-
All of the above
Question 25
Question
Pocket dosimeters and film badge must be worn where?
Answer
-
Shirt pocket
-
Back pants pocket
-
both A & B
-
None of the above
Question 26
Question
Radioactive Isotopes decay trying to get back to their stable state. During this process they give off Beta particles and ionizing radiation which your personal protective equipment can read.
Question 27
Question
Internal organs and cells are harmed by exposure to ionizing radiation.
Question 28
Question
What is the most common problem with survey meters?
Answer
-
Weak batteries
-
Dirt
-
Movement
Question 29
Question
A collimator's primary function is to:
Question 30
Question
Pocket dosimeters read:
Question 31
Question
Your pocket dosimeter falls and discharges before you shoot the first shot of the day, and the camera is still locked up. You resurvey the camera and get normal readings. What do you do?
Question 32
Question
During an exposure your source gets jammed, which of the following do you do?
Question 33
Question
You are in an enclosed room X-Raying. After an exposure you check your pocket dosimeter, and it is reading 12mR. You have one exposure left, what do you do?
Answer
-
Turn in your film badge for immediate processing and stop working
-
Continue working
-
Finish shooting,then contact your RSO
-
clock out and leave for the day
Question 34
Question
Target is usually made of:
Question 35
Question
The target creates X"Rays by; Rapid deceleration of electrons (Most energy given off as heat)
Question 36
Question
What makes a material a good absorber?
Question 37
Question
Why is steel not usually used in cameras as shielding?
Question 38
Question
Companies should do an inventory of source:
Answer
-
Daily
-
Weekly
-
Quarterly
-
Bi-weekly
-
Yearly
-
Every 6 months
Question 39
Question
The most common problem found during quarterly maintenance of exposure devices?
Answer
-
Broken Connector
-
Frayed pigtail
-
Dirt
-
All of the above
-
None of the above
Question 40
Question
What don't you record on a utilization log?
Answer
-
When a source is checked out
-
When the source is brought back in
-
The name of the technician checking out the source
-
Your surveys after each exposure
Question 41
Question
What do you record on a utilization log?
Answer
-
When a source is checked out
-
When the source is brought back in
-
The name of the technician checking;out the source
-
Your surveys after each exposure
Question 42
Question
What do you record on a utilization log?
Answer
-
When a source is checked out
-
When the source is brought back in
-
The name of the technician checking;out the source
-
Your surveys after each exposure
Question 43
Question
What do you record on a utilization log?
Answer
-
When a source is checked out
-
When the source is brought back in
-
The name of the technician checking;out the source
-
Your surveys after each exposure
Question 44
Question
W hat part of the camera is the most important part to survey after each exposure?
Answer
-
The front
-
The back
-
The sides
-
The top
-
The bottom
Question 45
Question
W hat part of the camera is the most important part to survey after each exposure?
Answer
-
The front
-
The back
-
The sides
-
The top
-
The bottom
Question 46
Question
W hat part of the camera is the most important part to survey after each exposure?
Answer
-
The front
-
The back
-
The sides
-
The top
-
The bottom
Question 47
Question
To do a proper survey after each exposure, you should: Survey all sides of the camera and the entire length of the source tube.
Question 48
Question
Range of survey meter?
Answer
-
2mR to 1,000mR (1R)
-
1R to 100R
-
.005mR to 1mR
-
None of the above
Question 49
Question
The range of pocket dosimeter is 0 to 200mR.
Question 50
Question
Survey meters are to be calibrated every ______ months
Question 51
Question
Pocket dosimeters are calibrated?
Question 52
Question
Your survey meter has been calibrated for use on C060. Can you use it for X-Rays?
Question 53
Question
Can an X-Ray systems control panel be locked out?
Question 54
Question
Your survey meter is set on x1? Your survey the camera and the meter is pegged out. What should you do?
Answer
-
Exit the area, reset meter to x10 and resurvey the camera
-
Move to a shielded area and see if the survey meter is responding properly
-
Ignore the survey meter, and continue working
Question 55
Question
What is the device called that allows the movement of the shielding or the source to make a radiographic exposure?
Question 56
Question
Ball stop: Prevents the source from being pulled out the back of the camera and locks it.
Question 57
Question
Safety Plug: Goes into the _________ of the camera to secure the source and keep out dirt.
Question 58
Question
Radiation output: (the type of radiation, not Curies).
Question 59
Question
What will increase the flow of electrons?
Answer
-
Less current
-
Less voltage
-
More current or voltage
-
Niether
Question 60
Question
If you increase the mA, you shorten the exposure proportionally {5mA to 10mA will cut the exposure time in half).
Question 61
Question
What on an x-ray determines the exposure of the film?
Answer
-
The Silver Bromide
-
The Gold Bromide
Question 62
Question
Safe line: _____ Radiation area: _____ High Radiation Area: ____ All are in any one hour
Answer
-
2mR, 6mR, 200mR
-
2mR, 5mR, 1R
-
2mR, 5mR, 100mR
-
None of the above
Question 63
Question
If you received a low level of radiation over a long period of time, what would be affected the most? (Bone marrow is the most sensitive-not an answer)
Question 64
Question
We receive more radiation from this than anything else?
Answer
-
Gamma Ray's
-
Medical X-Rays
-
X-Rays
Question 65
Question
Where would you find the information required to make a satisfactory exposure?
Question 66
Question
Where would you find the emergency numbers you may need while working in the field?
Question 67
Question
If you were in an-accident, what would your primary concern be?
Question 68
Question
You are making an exposure on across country pipeline. While setting up this exposure, what would be the most efficient way to set up the safe line?
Answer
-
Don't worry about a safe line, you're miles away from anyone.
-
Use ropes and signs to barricade off the 2mR line
-
None of the above
Question 69
Question
What are the delayed effects - of radiation?
1. Genetic effects 2. Radiation burns 3. Radiation sickness 4. Cancer
Answer
-
1 and 2
-
2 and 3
-
1 and 4
-
1,3 and 4
Question 70
Question
Why do you survey after you use a radiation machine?
Answer
-
To make sure the source is in the shielded position
-
To ensure the radiation being emitted is within the regulation limits
-
To make sure the X-Ray machine is off
Question 71
Question
You and -a radiographer are shooting for several hours at a temporary job site . You survey the barricade and find that you are receiving 4 mR/hr.What do you do?
Answer
-
Make sure your exposure time does hot exceed 45-minutes in any one hour.
-
Make sure your exposure time does hot exceed 30-minutes in any one hour.
-
Make sure your exposure time does hot exceed 20-minutes in any one hour.
-
Make sure your exposure time does hot exceed 10-minutes in any one hour.
-
None of the above
Question 72
Question
You are heading to a job site, and realize you left your film badge at the shop. What do you do?
Answer
-
Turn around and go get your film badge
-
Continue to the job site, and go about you business as if you had it
-
Get a new film badge
Question 73
Question
You are going into the field and will be using both gamma and X-ray equipment. Which of the following must be with you?
Question 74
Question
You drop your dosimeter while performing a shot. After recovering it, you find that it is off- scale. What do you do?
Question 75
Question
You are receiving 50mR/hr. How would you label this area?
Answer
-
High radiation area
-
Radiation area
-
Safe Line
Question 76
Question
You are making a shot, you check your dosimeter and find that you have received 55mR. What do you do?
Answer
-
Stop shooting, leave radiation area and contact your RSO
-
Continue shooting, you already have a high dose
-
Stop shooting and go home for the day without saying anything and hope nothing is said tomorrow.
Question 77
Question
What three things should you, while working as a radiographer, have on you at all times?
Answer
-
Film badge, TLD and dosimeter
-
Film badge or TLD, rate alarm and dosimeter
-
2 dosimeters, a film badge and a survey meter
Question 78
Question
You take an X-ray machine to a temporary job site. When is it OK to leave it alone?
Question 79
Question
What is the best.way to move an X-ray machine?
Question 80
Question
What is this? {Shows a picture of a SPECcamera)
Question 81
Question
What is the name of the federal agency that regulates radioactive sources and businesses?
Question 82
Question
Radioactive sources are never to be stored _____________?
Answer
-
within the city limits
-
inside a truck
-
in a residential area
-
none of the above
Question 83
Question
Where can you store a radioactive source?
Answer
-
Transport container
-
Security container
-
Both
-
Neither
Question 84
Question
A permanent facility is a site that is built for radioactive activity in a non-temporary facility.is called?
Question 85
Question
A temporary site that is built for radioactive activity is called a permanent facility?
Question 86
Question
What does an interlock do?
Answer
-
Allows exit from a room, but not entrance
-
Does not allow unwanted entry or exit
-
Keeps the camera locked, for transport
Question 87
Question
What type of shielding is this? (Diagram points to the material surrounding the S-tube)
Answer
-
Tungsten
-
Depleted Utanium
-
Neither