dt

1. advantages
   1. flaxible allowing user to be more comfortable
   2. low cost; it's cheaper than wire and solder
   3. discrete;able to be hidden well
2. disadvantages
   1. can catch on things breaking the circuit
   2. it's very time consuming to sew

1. advantages
   1. very fast to assemble;soldering can be done fast and acurately
   2. harder to break than conductive thread/more stable
   3. don't need to learn how to sew
2. disadvantages
   1. more costly than conductive thread
   2. not as flexible;less comfort for the user
   3. can be bulky and obvious

1. disadvantages
   1. can't carry out more complex code
   2. can only do basic functions
2. advantages
   1. more simple to write
   2. easier to follow
3. flow charts

1. advantages
   1. better for more complex code as very precise
   2. can carry out more complex code
   3. very detailed
2. disadvantages
   1. harder to write
   2. harder to follow
3. arduino
   1. functions
      1. void setup

         Nota:

         • runs once when Sketch starts, use it for things you need to do first or only once. used to start up Sketch basically
      2. void loop

         Nota:

         • a continuous looping function of code between parenthesis that follows. parenthesis={...}
      3. delay

         Nota:

         • wait normally in ms, 1000ms=1s
      4. pinMode ((write in pin number),(write in output/input in caps))

         Nota:

         • configures specified pin as an output or input pin
      5. digitalWrite((write in pin number)(write in high/low in caps)

         Nota:

         • turns specified pin on(HIGH) or off(LOW)
      6. remember all of the capital letters
   2. pin 13 is always/mostly an output

1. driven gear/driver gear

   Nota:

   • if draiver gear has 10 teeth and driven has 2 then gear ration=2/10=0.2
2. larger the driver gear smaller the ratio, larger the driven gear larger the ratio
3. output speed
   1. input speed/gear ratio

      Nota:

      • if draiver gear has 10 teeth and driven has 2 then gear ration=2/10=0.2 if the input speed is 50rpm then output speed=input/ratio=50/0.2=250

Nota:

• driver=input gear driven=output gear

Nota:

• a gear that makes the gears rotate the same way and don't change the gear ratio however the output speed will remain constant

Nota:

• swinging side to side

Nota:

• up and down

Nota:

• round and round