Performance 10

Performance 10

Power Saving Program
1. Decrease the Auxiliary Power
  1. Full Load
  2. Partial Load
Making BTG Operator a Key Player for Efficiency Improvement
1. Condenser pressure
2. Reheat temperature
3. Hot well temperature
4. Reheat spray flow
5. Exit Gas Temperature
6. Incomplete Combustion
7. Throttle pressure
8. Super heat temperature
9. Feed water temperature
10. Super heat spray flow
11. Station service power
12. Excess oxygen
Decrease the Loses
1. Mechanical
  1. Leak Control
    1. Internal Leak (Passing)
      1. Category 1
        Boiler (i.e., superheater header drains, reheat header drains, etc.)
        Turbine cycle drains (i.e., stop valve above and below seat drains, turbine loop line drains, trap on extraction piping, etc.)
      2. Category 2
        High pressure feedwater heater drains, Low pressure feedwater heater drains, Boiler feedwater pump minimum flow recirculation valves, Attemperation valves, etc.
    2. External Leak
      1. Category 3
        include all steam trap in the plant
      2. Category 4
        include all safety valves (steam or water)
2. Electrical
  1. Monthly report for all photo cell
  2. Controlling the electrical power of Offices Lighting, controlling the HVAC temperature in night and holidays
  3. Check the losses through transformer by Losses Test
Controlling the Startup & Shutdown Time
1. Cold Startup
2. Worm Startup
3. Hot Startup
4. Very Hot Startup
5. Shutdown
Control Boiler BlowDown
1. Chemical Injection Optimization
Efficiency Measurements
1. Performance Test
2. Cycle Circulation Test

Siguiente

Descripción

Resumen del Recurso

Similar

	Creado por Muhammed Al-Masmoum hace más de 8 años