Copiar e Editar

CCNA Wireless Pre test

Descrição

A CCNA Wireless practice test
davhow5368
Quiz por davhow5368, atualizado more than 1 year ago
davhow5368
Criado por davhow5368 mais de 8 anos atrás
287
0
0

Resumo de Recurso

Questão 1

Questão
The IEEE 802.11n standard provides 40-MHz channels, improved MAC efficiency, and MIMO. Which three elements define the 802.11n implementation of MIMO? (Choose three.)
Responda
  • channel bonding
  • dynamic frequency selection
  • maximal ratio combining
  • packet aggregation
  • spatial multiplexing
  • transmit beam forming

Questão 2

Questão
Which two statements about WiMAX technology are true? (Choose two.)
Responda
  • WiMAX is defined by 802.11i
  • Typically, fixed WiMAX networks have a higher-gain directional antenna installed near the client
  • WiMAX is capable of working as a long-range system over several miles.
  • WiMAX works only for licensed frequencies.

Questão 3

Questão
Which governing body analyzes the applications and environments in which wireless networks are used?
Responda
  • EIRP
  • ETSI
  • FCC
  • IEEE
  • WiFi Alliance

Questão 4

Questão
Which description best describes upfade in a multipath environment?
Responda
  • In this situation, multiple signal paths are not sent at exactly the same time. The receiver receives a positive crest on the primary signal and a negative crest on the secondary signal.
  • In this situation, the multiple signal paths are distorted and difficult to understand.
  • In this situation, the multiple signal paths are weaker than they should be because the signals are out of phase with each other
  • In this situation, the signal is stronger than it should be because multiple signal paths are received twice at exactly the same time, which results in the multiple signals being in-phase.

Questão 5

Questão
A controller is connected to a Cisco Catalyst switch. The switch port configuration looks like this: interface GigabitEthernet 1/0/10 switchport switchport trunk encapsulation dot1q switchport trunk allowed vlan 1,20,30,50 switchport trunk native vlan 20 switchport mode trunk Which controller CLI command assigns its management interface to the native VLAN interface of the Cisco Catalyst switch?
Responda
  • config interface vlan management 0
  • config interface vlan management 1
  • config interface vlan management 20
  • . config interface vlan management 30
  • config interface vlan management 50

Questão 6

Questão
Which statement about an infrastructure basic service set is true according to IEEE 802.11 specifications?
Responda
  • The set also is called an ad hoc network
  • The BSSID is generated from the first wireless client that starts up in the IBSS.
  • The set enables the use of ESS.
  • No signals are relayed from one client to another client.

Questão 7

Questão
Which two factors must be considered when evaluating an RF interferer for severity? (Choose two.)
Responda
  • distance from the AP
  • dBm
  • the type of security crack being used
  • duty cycle
  • number of interfering IP stations in the cell
  • duplicate SSID

Questão 8

Questão
Which two items are needed to discover the IP address of a new Cisco Aironet 1260 autonomous AP that just finished booting? (Choose two.)
Responda
  • username = "cisco" and password = "cisco"
  • username = "Admin" and password = "Cisco"
  • username=Cisco and password=Cisco
  • show int vlan1
  • show int bvi1
  • show int gigabitethernet0
  • show int radio0-802.11n
  • show int radio1-802.11n

Questão 9

Questão
Which statement correctly describes the procedure for a lightweight AP to successfully establish a connection to a controller?
Responda
  • The AP authenticates the received Cisco WLC certificate as valid. The AP then sends its certificate to the controller.
  • The AP sends its certificate to the controller. The AP then authenticates the received Cisco WLC certificate as valid.
  • The AP sends its certificate to the RADIUS server. The AP then authenticates the controller certificate as valid.
  • . The AP sends its certificate to the RADIUS server. The AP then authenticates the RADIUS certificate as valid.
  • The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the RADIUS server
  • The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the controller

Questão 10

Questão
Which two statements about the requirements to configure inter-controller roaming are true? (Choose two.)
Responda
  • The same mobility domain names are configured across controllers.
  • The same RF group names are configured across controllers.
  • The same controller hardware version is configured across controllers
  • The same AP manager interface is configured across controllers.
  • The same virtual interface is configured across controllers.
  • The same controller software version is configured across controllers.

Questão 11

Questão
Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)
Responda
  • The Catalyst switch should be configured for PAgP.
  • The Catalyst switch should be configured only for Layer 2 load balancing.
  • The Catalyst switch should be configured for "on" mode
  • The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
  • The Cisco WLC aggregates multiple management interfaces into a single virtual interface.

Questão 12

Questão
Which two Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages in version 7.0 MR1? (Choose two.)
Responda
  • aggressive load balancing
  • dynamic channel assignment
  • hybrid remote edge access point
  • inter-controller mobility (that is, mobility groups)
  • rogue AP classification

Questão 13

Questão
The wireless network is using controller-based APs and version 7.0 MR1. The APs appear to be connected properly to the controllers. A wireless user near one of the APs reports that they are unable to connect to the network with their pre-shared key. Which option shows the GUI path where you can check the connection status of that client?
Responda
  • WLANs > WLAN_ID > Advanced
  • Security > Clients
  • Security > Advanced > Clients
  • Monitor > Clients
  • Wireless > 802.11b/g/n > clients

Questão 14

Questão
You are about to use a hotel's guest wireless services using a wireless laptop. Which three items do you need to establish a wireless connection? (Choose three.)
Responda
  • SSID name
  • RF channel
  • RF signal
  • 802.1X/EAP credentials
  • pre-shared key
  • web page
  • WPA/WPA2 settings

Questão 15

Questão
You have an Apple IOS iPhone4 that is used on your home Wi-Fi network and a personal laptop that is used on your work's enterprise wireless network. At your office, you are unable to see the enterprise wireless network on your iPhone4. What is the most likely cause of this issue?
Responda
  • WPA2 CPU intensive encryption is not supported on the client.
  • WPA2 must be enabled on the client
  • A new profile must be created on the client.
  • Wi-Fi must be enabled on the client.
  • The enterprise is 2.4 GHz only
  • The enterprise is 5 GHz only
  • The RF channel must be adjusted on the client.

Questão 16

Questão
When Cisco AnyConnect modules are installed on a PC, which module must be installed first?
Responda
  • telemetry
  • web security
  • VPN
  • NAM
  • DART
  • posture
  • CSSC

Questão 17

Questão
Which option lists the key features of Cisco Compatible Extensions v5?
Responda
  • Roaming and real-time diagnostics, MFP, a diagnostic channel that allows troubleshooting of the client, client reporting, optional location service, and expedited bandwidth.
  • AP assisted roam, Cisco Centralized Key Management, radio measurements, and transmit power control.
  • CAC, UPSD, voice metrics, MBSSIDs, location, link tests, and NAC.
  • WME, proxy ARP, EAP-FAST, and WPA2, and single sign-on.
  • LEAP, WPA, 802.1x and VLANs per AP, TKIP, and WiFi.

Questão 18

Questão
A client is attached to the Cisco Unified Wireless Network using controllers. When the client is using WPA2 and EAP authentication, where are the wireless encryption keys located during the active user session? (Choose two.)
Responda
  • on the access point
  • on the RADIUS server
  • on the Cisco WCS
  • on the client
  • on the Cisco WLC

Questão 19

Questão
Which Extensible Authentication Protocol types are supported by the Cisco Unified Wireless Network?
Responda
  • EAP-TLS, PEAP-MSCHAPv2, and PEAP-GTC only.
  • LEAP and EAP-FAST only.
  • EAP-TLS, PEAP-MSCHAPv2, PEAP-GTC, LEAP, and EAP-FAST only
  • Any EAP supported by the RADIUS authentication server.

Questão 20

Questão
Which four parameters must be configured for local EAP-FAST on the controller? (Choose four.)
Responda
  • authority ID
  • authority ID Information
  • client key
  • PAC
  • server key
  • TTL for PAC
  • monitor key
  • NTP source

Quer criar seus próprios Quizzes gratuitos com a GoConqr? Saiba mais.

Semelhante

CCNA Security Final Exam
Maikel Degrande
Security Guard Training
Summit College
ISACA CISM Exam Glossary
Fred Jones
Security
annelieserainey
Securities Regulation
harpratap_singh
2W151 Volume 1: Safety and Security - Quiz 7
Joseph Whilden J
Security Quiz Review
Rylan Blah
Security Policies
indysingh7285
2W151 Volume 1: Safety and Security - Quiz 6
Joseph Whilden J
Security (2)
Daniel Freedman
Certified Security Compliance Specialist
jnkdmls
Explore a Biblioteca