15930771
Beschreibung
Quiz von Jose Antonio Vazquez, aktualisiert more than 1 year ago
|
Erstellt von Jose Antonio Vazquez
vor etwa 6 Jahre
|
|
Frage 1
Frage
51) For a turboprop powered aeroplane, a 2200 m long runway at the destination aerodrome is expected to be "wet". The "dry runway" landing distance, should not exceed:
Antworten
-
1540 m.
-
1147 m.
-
1339 m.
-
1771 m.
Frage 2
Frage
65) An aeroplane executes a steady glide at the speed for minimum glide angle. If the forward speed is kept constant, what is the effect of a lower mass?
Rate of descent / Glide angle / CL/CD ratio
Antworten
-
decreases / constant / decreases
-
increases / increases / constant
-
increases / constant / increases
-
increases / increases / decreases
Frage 3
Frage
66) Which of the following statements is correct?
Antworten
-
Induced drag decreases with increasing speed.
-
Induced drag increases with increasing speed.
-
Induced drag is independant of the speed.
-
Induced drag decreases with increasing angle of attack.
Frage 4
Frage
67) A flight is planned with a turbojet aeroplane to an aerodrome with a landing distance available of 2400 m. Which of the following is the maximum landing distance for a dry runway?
Antworten
-
1 440 m.
-
1 250 m.
-
1 090 m.
-
1 655 m.
Frage 5
Frage
68) How does the thrust of fixed propeller vary during take- off run ? The thrust
Antworten
-
increases slightly while the aeroplane speed builds up.
-
varies with mass changes only.
-
has no change during take-off and climb.
-
decreases slightly while the aeroplane speed builds up.
Frage 6
Frage
69) Which of the following statements is correct?
Antworten
-
VR is the speed at which, during rotation, the nose wheel comes off the runway.
-
VR is the speed at which the pilot should start to rotate the aeroplane.
-
VR should not be higher than V1.
-
VR should not be higher than 1.05 VMCG.
Frage 7
Frage
70) Field length is balanced when
Antworten
-
one engine acceleration from V1 to VLOF plus flare distance between VLOF and 35 feet are equal.
-
take-off distance equals accelerate-stop distance.
-
calculated V2 is less than 110% VMCA and V1, VR, VMCG.
-
all engine acceleration to V1 and braking distance for rejected take-off are equal.
Frage 8
Frage
72) Which of the following answers is true?
Antworten
-
V1>VR
-
V1 < VMCG
-
V1<=VR
-
V1 > Vlof
Frage 9
Frage
166) Which of the equations below expresses approximately the unaccelerated percentage climb gradient for small climb angles?
Antworten
-
Climb Gradient = ((Thrust - Drag)/Weight) x 100
-
Climb Gradient = ((Thrust + Drag)/Lift) x 100
-
Climb Gradient = ((Thrust - Mass)/Lift) x 100
-
Cimb Gradient = (Lift/Weight) x 100
Frage 10
Frage
62) On a long distance flight the gross mass decreases continuously as a consequence of the fuel consumption. The result is:
Antworten
-
The speed must be increased to compensate the lower mass.
-
The specific range increases and the optimum altitude decreases.
-
The specific range decreases and the optimum altitude increases.
-
The specific range and the optimum altitude increases.
Frage 11
Frage
41) The Density Altitude
Antworten
-
is used to calculate the FL above the Transition Altitude.
-
is used to determine the aeroplane performance.
-
is equal to the pressure altitude.
-
is used to establish minimum clearance of 2.000 feet over mountains.
Frage 12
Frage
30) The climb gradient of an aircraft after take-off is 6% in standard atmosphere, no wind, at 0 ft pressure altitude. Using the following corrections:
"± 0,2 % / 1 000 ft field elevation"
"± 0,1 % / °C from standard temperature" " - 1 % with wing anti-ice"
" - 0,5% with engine anti-ice"
The climb gradient after take-off from an airport situated at 1 000 ft, 17° C; QNH 1013,25 hPa, with wing and engine anti-ice operating for a functional check is :
Antworten
-
3,9 %
-
4,3 %
-
4,7 %
-
4,9 %
Frage 13
Frage
31) Which one of the following statements concerning drift- down is correct?
Antworten
-
The drift-down procedure requires a minimum descent angle after an engine failure at cruising altitude.
-
The drift-down procedure requires a minimum obstacle clearance of 35 ft.
-
An engine failure at high cruising altitude will always result in a drift-down, because it is not permitted to fly the same altitude with one engine inoperative as with all engines operating.
-
When determining the obstacle clearance during drift-down, fuel dumping may be taken into account.
Frage 14
Frage
32) Two identical turbojet aeroplanes (whose specific fuel consumption is assumed to be constant) are in a holding pattern at the same altitude. The mass of the first one is 95 000 kg and its hourly fuel consumption is equal to 3100 kg/h. Since the mass of the second one is 105 000 kg, its hourly fuel consumption is:
Antworten
-
3787 kg/h
-
3426 kg/h
-
3259 kg/h
-
3602 kg/h
Frage 15
Frage
33) As long as an aeroplane is in a positive climb
Antworten
-
VX is always below VY.
-
VX is sometimes below and sometimes above VY depending on altitude.
-
VX is always above VY.
-
VY is always above VMO.
Frage 16
Frage
34) What is the advantage of balancing V1, even in the event of a climb limited take-off?
Antworten
-
The safety margin with respect to the runway length is greatest.
-
The take-off distance required with one engine out at V1 is the shortest.
-
The accelerate stop distance required is the shortest.
-
The climb limited take-off mass is the highest.
Frage 17
Frage
35) What happens to the drag of a jet aeroplane if, during the initial climb after take off, constant IAS is maintained?
(Assume a constant mass.)
Antworten
-
The drag decreases.
-
The drag increases initially and decreases thereafter.
-
The drag remains almost constant.
-
The drag increases considerably.
Frage 18
Frage
36) The point where Drag coefficient/Lift coefficient is a minimum is
Antworten
-
at stalling speed (VS).
-
on the "back side" of the drag curve.
-
the point where a tangent from the origin touches the drag curve.
-
the lowest point of the drag curve.
Frage 19
Frage
37) The speed VR
Antworten
-
must be higher than VLOF.
-
must be equal to or lower than V1.
-
is the speed at which rotation to the lift-off angle of attack is initiated.
-
must be higher than V2.
Frage 20
Frage
38) At a given mass, the stalling speed of a twin engine aircraft is 100 kt in the landing configuration. The minimum speed a pilot must maintain in short final is:
Antworten
-
130 kt
-
115 kt
-
125 kt
-
120 kt
Frage 21
Frage
53) When the outside air temperature increases, then
Antworten
-
the field length limited take-off mass decreases but the climb limited take-off mass increases.
-
the field length limited take-off mass increases but the climb limited take-off mass decreases.
-
the field length limited take-off mass and the climb limited take-off mass decreases.
-
the field length limited take-off mass and the climb limited take-off mass increases.
Frage 22
Frage
40) For take-off obstacle clearance calculations, obstacles in the first segment may be avoided
Antworten
-
by banking not more than 15° between 50 ft and 400 ft above the runway elevation.
-
by banking as much as needed if aeroplane is more than 50 ft above runway elevation.
-
only by using standard turns.
-
by standard turns - but only after passing 1500 ft.
Frage 23
Frage
74) A jet aeroplane is climbing at constant Mach number below the tropopause. Which of the following statements is correct?
Antworten
-
IAS decreases and TAS decreases.
-
IAS increases and TAS increases.
-
IAS decreases and TAS increases.
-
IAS increases and TAS decreases.
Frage 24
Frage
42) Which of the following factors leads to the maximum flight time of a glide?
Antworten
-
High mass.
-
Low mass.
-
Headwind.
-
T ailwind.
Frage 25
Frage
43) A constant headwind
Antworten
-
increases the descent distance over ground.
-
increases the angle of the descent flight path.
-
increases the angle of descent.
-
increases the rate of descent.
Frage 26
Frage
44) The second segment begins
Antworten
-
when landing gear is fully retracted.
-
when flap retraction begins.
-
when flaps are selected up.
-
when acceleration starts from V2 to the speed for flap retraction.
Möchten Sie mit GoConqr kostenlos Ihre eigenen Quiz erstellen? eigenen Mehr erfahren.