2817962
Beschreibung
Quiz von Oliver Balay, aktualisiert more than 1 year ago
|
Erstellt von Oliver Balay
vor mehr als 9 Jahre
|
|
Frage 1
Frage
Electric current is described as a flow of
Antworten
-
protons
-
neutrons
-
electrons
-
nucleus
Frage 2
Frage
Which one of the following identifies the sources of an electromotive force?
Antworten
-
Atomic, magnetic, thermal
-
Chemical, atomic, thermal
-
Chemical, magnetic, thermal
-
Chemical, magnetic, atomic
Frage 3
Frage
When the current passing through a conductor is increased, the conductor’s temperature will:
Antworten
-
decrease
-
stabilise
-
fragment
-
increase
Frage 4
Antworten
-
capacitance
-
inductance
-
frequency
-
flux density
Frage 5
Frage
Ohm is the SI unit of measurement for:
Antworten
-
resistance
-
voltage
-
current
-
charge
Frage 6
Antworten
-
Joule
-
Mole
-
Farad
-
Hertz
Frage 7
Frage
Resistance, potential difference and electrical current are expressed in the same order as units of:
Antworten
-
Ohms, Volts, Amperes
-
Ohms, Watts, Amperes
-
Ohms, Volts, Watts
-
Watts, Volts, Ohms
Frage 8
Frage
Transpose the formula Z² = R² + X² to make R² the subject.
Antworten
-
R² = X² – Z²
-
R² = Z² – X²
-
R² = Z² + X²
-
R² = X² x Z²
Frage 9
Frage
If the resistivity of aluminium is 2.65 x 10 -8 /metre, the resistance of a 65 metre length of 16mm2 aluminium conductor is:
Antworten
-
10.77Ω
-
1.108Ω
-
0.0108Ω
-
0.108Ω
Frage 10
Frage
For the circuit shown, the total resistance is:
Antworten
-
108Ω
-
36Ω
-
12Ω
-
3.6Ω
Frage 11
Frage
For the circuit shown, the power dissipated by the 15Ω resistor is:
Antworten
-
240W
-
60W
-
160W
-
40W
Frage 12
Frage
The power dissipated in the circuit shown on the right would be:
Antworten
-
35W
-
833W
-
350W
-
1,399W
Frage 13
Frage
When measuring current flow in a d.c. circuit, an ammeter must be connected:
Antworten
-
using a rectifier
-
using a VT
-
in series with the load
-
in parallel with the load
Frage 14
Frage
Instrument B in the figure on the right measures the:
Antworten
-
voltage drop caused by R2
-
voltage drop caused by R3
-
current through R1
-
current through R2
Frage 15
Frage
The strength of the magnetic flux produced when current flows in a conductor can be increased by:
Antworten
-
increasing the current
-
decreasing the current
-
reversing the current
-
using alternating current
Frage 16
Frage
Which one of the following shows the correct poles of the electromagnet when current flows in the direction shown?
Antworten
-
a)
-
b)
-
c)
-
d)
Frage 17
Frage
What would be the effect on magnetic flux for the two equal, current-carrying conductors shown?
Antworten
-
The magnetic field would halve in strength, flowing in opposite directions
-
The magnetic fields around each of the conductors would rotate independently
-
The magnetic fields around the conductors would cancel each other out
-
The magnetic field around the conductors would double in strength and flow in the same direction
Frage 18
Frage
A conductor of a simple alternator is 0.4m long and cuts a magnetic field with a magnetic flux density of 1.5 tesla at a velocity of 30m/s. The EMF induced in the conductor will be:
Antworten
-
1,800V
-
180V
-
18V
-
1.8V
Frage 19
Frage
Which one of the following is the supply frequency if a sine wave has a periodic time of 20 milliseconds?
Antworten
-
40Hz
-
50Hz
-
60Hz
-
70Hz
Frage 20
Frage
Refer to the figure shown. What does value A indicate?
Antworten
-
Average value of the waveform
-
Periodic time of the waveform
-
RMS value of the waveform
-
Peak amplitude of the waveform
Frage 21
Frage
Which one of the following quantities can be described as a force?
Antworten
-
Gravity
-
Current
-
Resistance
-
Energy
Frage 22
Frage
The formula shown is used to determine the force required given mass and acceleration. Which one of the following would be the acceleration for a mass of 20kg having a force of 10N applied? F = m x a
Antworten
-
200 m/s²
-
0.5 m/s²
-
5 m/s²
-
50 m/s²
Frage 23
Frage
The power required to raise a mass of 8kg across a distance of 10m in 40 seconds is approximately:
Antworten
-
785W
-
80W
-
20W
-
5W
Frage 24
Frage
A motor produces an output of 1.2kW when the input is 1.4kW; its efficiency is:
Antworten
-
85.7%
-
75.7%
-
65.7%
-
55.7%
Frage 25
Frage
When used to ‘inch’ heavy equipment across the floor, a crowbar is being:
Antworten
-
a pulley
-
a lift
-
a machine
-
a lever
Frage 26
Frage
Which one of the following instruments would be used to measure the line voltage for the star connected load?
Antworten
-
A
-
B
-
C
-
D
Frage 27
Frage
In a four-wire, three phase system the phase voltage is 220v. The line voltage will be:
Antworten
-
380V
-
400V
-
415V
-
420V
Frage 28
Frage
Which one of the following is the phase voltage for a star connected load if the line voltage is 400V?
Antworten
-
400V
-
230V
-
110V
-
50V
Frage 29
Frage
Which one of the following instruments would be used to measure the line current for the delta connected load?
Antworten
-
A
-
B
-
C
-
D
Frage 30
Frage
The line current feeding a delta load is 52A. The delta phase current will be:
Antworten
-
30A
-
52A
-
90A
-
156A
Frage 31
Frage
The phase current in a delta load is 10A. The line current will be:
Antworten
-
5A
-
5.8A
-
10A
-
17.3A
Frage 32
Frage
A balanced three phase star connected load draws a line current of 24A per phase. Which of the following is the approximate value of neutral current?
Antworten
-
0A
-
8A
-
13.9A
-
24A
Frage 33
Frage
A d.c. motor in which the current remains constant in the field winding but varies in the armature winding is called:
Antworten
-
a compound machine
-
an armature machine
-
a shunt machine
-
a series machine
Frage 34
Frage
If a single loop of wire connected to a commutator is rotated in a permanent magnetic field, the voltage measured at the commutator will be:
Antworten
-
d.c.
-
a.c.
-
intermittent
-
unidirectional
Frage 35
Frage
The diagram shows a simple motor, indicating the field poles and direction of current flow. In which one of the following directions would the conductor move?
Antworten
-
Direction A
-
Direction B
-
Direction C
-
Direction D
Frage 36
Frage
In a 400v to 4,000v step-up transformer the ratio of primary to secondary turns ratio will be:
Antworten
-
10:1
-
5:1
-
1:5
-
1:10
Frage 37
Frage
Which one of the following components would cause current and voltage to behave as indicated in the sine wave shown?
Antworten
-
Rectifier
-
Capacitor
-
Inductor
-
Resistor
Frage 38
Frage
The power triangle shown gives the relationship between powers in an a.c. circuit. Which one of the following is the unit used to measure Apparent power?
Antworten
-
kW
-
kVA
-
kVAr
-
kJ
Frage 39
Frage
A circuit dissipates 3kW at a power factor of 0.7 when connected to a 230V a.c. supply. The current flowing in the circuit will be:
Antworten
-
13.0A
-
18.6A
-
21.5A
-
25.2A
Frage 40
Frage
Power factor correction in circuits having lagging power factors can be achieved by connecting:
Antworten
-
inductors across the load
-
resistors across the load
-
resistors in series with the load
-
capacitors across the load
Möchten Sie mit GoConqr kostenlos Ihre eigenen Quiz erstellen? eigenen Mehr erfahren.