2817962
Descrição
Quiz por Oliver Balay, atualizado more than 1 year ago
|
Criado por Oliver Balay
mais de 9 anos atrás
|
|
Questão 1
Questão
Electric current is described as a flow of
Responda
-
protons
-
neutrons
-
electrons
-
nucleus
Questão 2
Questão
Which one of the following identifies the sources of an electromotive force?
Responda
-
Atomic, magnetic, thermal
-
Chemical, atomic, thermal
-
Chemical, magnetic, thermal
-
Chemical, magnetic, atomic
Questão 3
Questão
When the current passing through a conductor is increased, the conductor’s temperature will:
Responda
-
decrease
-
stabilise
-
fragment
-
increase
Questão 4
Responda
-
capacitance
-
inductance
-
frequency
-
flux density
Questão 5
Questão
Ohm is the SI unit of measurement for:
Responda
-
resistance
-
voltage
-
current
-
charge
Questão 6
Questão
The SI unit for frequency is the
Responda
-
Joule
-
Mole
-
Farad
-
Hertz
Questão 7
Questão
Resistance, potential difference and electrical current are expressed in the same order as units of:
Responda
-
Ohms, Volts, Amperes
-
Ohms, Watts, Amperes
-
Ohms, Volts, Watts
-
Watts, Volts, Ohms
Questão 8
Questão
Transpose the formula Z² = R² + X² to make R² the subject.
Responda
-
R² = X² – Z²
-
R² = Z² – X²
-
R² = Z² + X²
-
R² = X² x Z²
Questão 9
Questão
If the resistivity of aluminium is 2.65 x 10 -8 /metre, the resistance of a 65 metre length of 16mm2 aluminium conductor is:
Responda
-
10.77Ω
-
1.108Ω
-
0.0108Ω
-
0.108Ω
Questão 10
Questão
For the circuit shown, the total resistance is:
Responda
-
108Ω
-
36Ω
-
12Ω
-
3.6Ω
Questão 11
Questão
For the circuit shown, the power dissipated by the 15Ω resistor is:
Responda
-
240W
-
60W
-
160W
-
40W
Questão 12
Questão
The power dissipated in the circuit shown on the right would be:
Responda
-
35W
-
833W
-
350W
-
1,399W
Questão 13
Questão
When measuring current flow in a d.c. circuit, an ammeter must be connected:
Responda
-
using a rectifier
-
using a VT
-
in series with the load
-
in parallel with the load
Questão 14
Questão
Instrument B in the figure on the right measures the:
Responda
-
voltage drop caused by R2
-
voltage drop caused by R3
-
current through R1
-
current through R2
Questão 15
Questão
The strength of the magnetic flux produced when current flows in a conductor can be increased by:
Responda
-
increasing the current
-
decreasing the current
-
reversing the current
-
using alternating current
Questão 16
Questão
Which one of the following shows the correct poles of the electromagnet when current flows in the direction shown?
Responda
-
a)
-
b)
-
c)
-
d)
Questão 17
Questão
What would be the effect on magnetic flux for the two equal, current-carrying conductors shown?
Responda
-
The magnetic field would halve in strength, flowing in opposite directions
-
The magnetic fields around each of the conductors would rotate independently
-
The magnetic fields around the conductors would cancel each other out
-
The magnetic field around the conductors would double in strength and flow in the same direction
Questão 18
Questão
A conductor of a simple alternator is 0.4m long and cuts a magnetic field with a magnetic flux density of 1.5 tesla at a velocity of 30m/s. The EMF induced in the conductor will be:
Responda
-
1,800V
-
180V
-
18V
-
1.8V
Questão 19
Questão
Which one of the following is the supply frequency if a sine wave has a periodic time of 20 milliseconds?
Responda
-
40Hz
-
50Hz
-
60Hz
-
70Hz
Questão 20
Questão
Refer to the figure shown. What does value A indicate?
Responda
-
Average value of the waveform
-
Periodic time of the waveform
-
RMS value of the waveform
-
Peak amplitude of the waveform
Questão 21
Questão
Which one of the following quantities can be described as a force?
Responda
-
Gravity
-
Current
-
Resistance
-
Energy
Questão 22
Questão
The formula shown is used to determine the force required given mass and acceleration. Which one of the following would be the acceleration for a mass of 20kg having a force of 10N applied? F = m x a
Responda
-
200 m/s²
-
0.5 m/s²
-
5 m/s²
-
50 m/s²
Questão 23
Questão
The power required to raise a mass of 8kg across a distance of 10m in 40 seconds is approximately:
Responda
-
785W
-
80W
-
20W
-
5W
Questão 24
Questão
A motor produces an output of 1.2kW when the input is 1.4kW; its efficiency is:
Responda
-
85.7%
-
75.7%
-
65.7%
-
55.7%
Questão 25
Questão
When used to ‘inch’ heavy equipment across the floor, a crowbar is being:
Responda
-
a pulley
-
a lift
-
a machine
-
a lever
Questão 26
Questão
Which one of the following instruments would be used to measure the line voltage for the star connected load?
Responda
-
A
-
B
-
C
-
D
Questão 27
Questão
In a four-wire, three phase system the phase voltage is 220v. The line voltage will be:
Responda
-
380V
-
400V
-
415V
-
420V
Questão 28
Questão
Which one of the following is the phase voltage for a star connected load if the line voltage is 400V?
Responda
-
400V
-
230V
-
110V
-
50V
Questão 29
Questão
Which one of the following instruments would be used to measure the line current for the delta connected load?
Responda
-
A
-
B
-
C
-
D
Questão 30
Questão
The line current feeding a delta load is 52A. The delta phase current will be:
Responda
-
30A
-
52A
-
90A
-
156A
Questão 31
Questão
The phase current in a delta load is 10A. The line current will be:
Responda
-
5A
-
5.8A
-
10A
-
17.3A
Questão 32
Questão
A balanced three phase star connected load draws a line current of 24A per phase. Which of the following is the approximate value of neutral current?
Responda
-
0A
-
8A
-
13.9A
-
24A
Questão 33
Questão
A d.c. motor in which the current remains constant in the field winding but varies in the armature winding is called:
Responda
-
a compound machine
-
an armature machine
-
a shunt machine
-
a series machine
Questão 34
Questão
If a single loop of wire connected to a commutator is rotated in a permanent magnetic field, the voltage measured at the commutator will be:
Responda
-
d.c.
-
a.c.
-
intermittent
-
unidirectional
Questão 35
Questão
The diagram shows a simple motor, indicating the field poles and direction of current flow. In which one of the following directions would the conductor move?
Responda
-
Direction A
-
Direction B
-
Direction C
-
Direction D
Questão 36
Questão
In a 400v to 4,000v step-up transformer the ratio of primary to secondary turns ratio will be:
Responda
-
10:1
-
5:1
-
1:5
-
1:10
Questão 37
Questão
Which one of the following components would cause current and voltage to behave as indicated in the sine wave shown?
Responda
-
Rectifier
-
Capacitor
-
Inductor
-
Resistor
Questão 38
Questão
The power triangle shown gives the relationship between powers in an a.c. circuit. Which one of the following is the unit used to measure Apparent power?
Responda
-
kW
-
kVA
-
kVAr
-
kJ
Questão 39
Questão
A circuit dissipates 3kW at a power factor of 0.7 when connected to a 230V a.c. supply. The current flowing in the circuit will be:
Responda
-
13.0A
-
18.6A
-
21.5A
-
25.2A
Questão 40
Questão
Power factor correction in circuits having lagging power factors can be achieved by connecting:
Responda
-
inductors across the load
-
resistors across the load
-
resistors in series with the load
-
capacitors across the load
Quer criar seus próprios Quizzes gratuitos com a GoConqr? Saiba mais.